Sons of Anarchy Iron/Sew On Large Skull Skeleton Embroidered Biker Jacket Patch 12"X8.5" -P46B


Embroidered Patch as Shown in Picture

Can be Sew-on, Applique or Iron-on 

Size of Each Patch : Length 12 inch Width 8.5 inch

CONDITION: BRAND NEW 

 


Guide to iron-on a Patch

  • Lay your cloth on a ironing board like flat heat resisting surface. To ensure the item will provide a good surface for the patch, iron it first. If it's a backpack or another item that's difficult to iron, do your best to arrange it so that the part of the fabric that will be receiving the patch is flat against a hard surface.
  • Place the patch in the position according to your requirement. Keep the adhesive side flat against the base fabric. Patch should not be crooked. On embroidered patches, the adhesive side is the underside.
  • Heat up an iron. Turn it to the hottest setting your fabric can tolerate. Turn off the steam option and make sure that your iron isn't full of water.
  • Place a thin towel or a cotton fabrice over the patch. Take care not to disturb the position of the patch. The towel will protect the patch itself and the surrounding fabric.
  • Position the heated iron over the patch and press down. Hold the iron there for about 15 seconds. Apply as much pressure as you can by pressing down firmly.
  • Remove the iron and allow the patch to to cool. Lift the towel and check to see whether the patch is fixed on securely by gently rubbing at the edge with a finger, trying to lift it. If it lifts up a bit, replace the towel and press it with the iron again for 10 seconds.

  

 Note: Due to the difference between different monitors, the picture may not reflect the actual colour of the item. We guarantee the style is the same as shown in the pictures.