R0557100 Pressure Gauge Adapter with O-Ring Seal,Compatible with Zodiac Jandy Cs Series Cartridge Filters
Product Features:
R0557100 Pressure Gauge Adapter with O-Ring Seal compatible with Zodiac Jandy Cs Series Cartridge Filter Models CS100, CS150, CS200, CS250.
The R0557100 pressure gauge adapter is made of high quality plastic, waterproof, durable and corrosion resistant. The O-ring is made of rubber, which has good elasticity, good sealing, durable and not easy to break.
One each of R0557100 pressure gauge adapter and O-ring seal. Replacement Part Number: R0557100.
Precautions: If it is the first replacement, you need to pay attention,never start pump while standing within five feet of the filter or operate the filter system at more than 50 psi of pressure. Starting the pump while there is any pressure in the system can cause the filter lid to be blown off, which can cause death, serious personal injury, or property damage.
Order from now on, if you have other questions about the R0557100 Pressure Gauge Adapter with O-Ring Seal, you can communicate with us at the first time, We will offer you a full refund within 30 days of return, as well as a 12-month quality guarantee. We are always available to provide you with support and help, you can rest assured to buy.
Descriptions:
The Pressure Gauge adapter is designed to replace for Zodiac R0557100,
and is compatibility with many Zodiac Jandy CS/CJ series cartridge.
CS series cartridge filter models: CS100, CS150, CS200, CS250
CJ series cartridge filter models: CJ200, CJ250.
Installation Procedure:
turn off the oil pump first, and close the circuit breaker to the pump motor. Be careful to open the air release valve at the top of the filter tank first, release all the air pressure inside, and ensure that the valve is open. Remove the old pressure gauge and then remove the pressure gauge adapter. Put the new O-ring on the new gauge adapter. Install the pressure gauge adapter to the top of the filter storage tank. Just tighten, don't over tighten. Install the pressure gauge into the adapter on top of the filter reservoir. Just tighten, don't over tighten. Then check whether it can be pneumatic.
