eBay

Scotty's Sled Shed Multi-Section Capacitor Board 4 in 1 Multi-Cap Circuit Board

Custom replacement circuit board to replace the 1 3/8" (35mm) diameter Multi-Sector/Multi-Section old can style capacitors with the 46mm flange mounting holes, found in vintage electronics. 600V maximum so you can use your 525 volt capacitors used in high voltage power supplies and amplifier applications.

This will not fit the smaller 7/8-1" (29mm) can capacitors with the 38mm mounting flange. I have a custom board for those as well at: https://www.ebay.com/itm/175968305593

1.6mm PCB with 2oz of copper. These are very robust boards made professionally in a factory to meet IPC-2221B specifications.

These are the boards I sell with my Restoration Component Kits. Custom designed specifically for vintage electronics replacement applications.

Includes spacer board, 4 soldering turrets and a grounding lug. Both outer mounting holes are tied to the center grounding pin.

The positive mount inside with negative terminal outside, to simulate original capacitor configuration.

Can common negative. If you need to isolate the ground from chassis or have negative bias type capacitor (some audio applications like the Fisher 500) I have an isolation kit also available at:

The Spacer board installs on the "Cap Side" of the board to provide additional clearance to the solder post turrets.

I can put together a kit (extra charge) with capacitors if I have those values in stock. Just send me an ebay message of what you are looking for.

Now the legal stuff:

CAUTION! These units have lethal voltages inside. CAUTION!

Buyer takes full responsibility for their own safety and ensuring they have the skillsets to install the kit.

Scotty's Sled Shed LLC is NOT RESPONSIBLE for any injuries, or damage you incur installing this kit.

Buyer takes full responsibility for themselves.