This charger is controlled by a 12-bit ADC high-precision microcontroller. The output interface monitoring resolution can reach 5mV. It can accurately judge the battery status and automatically stop when full. It can charge 10 strings of NiMH NiCd battery packs at the same time.
Features:
AC100-240V wide voltage input.
The ultra-low reverse current is <1uA. Even if the battery is not connected to the power supply and is connected to the charger for a long time, it will not cause over-discharge and damage the battery.
Fully automatic identification of 2-10 strings in an ultra-wide range, and automatically adjusts the best charging parameters.
The 0-voltage battery pack can be activated and charged.
Bad battery identification, a battery that cannot be activated at all is judged as a bad battery.
Battery packs with protective diodes can be charged.
Short circuit protection, reverse connection protection, overcharge protection.
Multiple ways to determine satiety: -ΔV, 0ΔV.
Can charge 2-10 cells in series 200-3000mAH Ni-MH or Ni-Cd battery pack.
Input voltage 85 - 265 V
Input current 0.2 A
Output voltage no load 18.5 19 19.8 V
Charging current can be automatically adjusted from 400 - 1100 mA
Maximum charging time 9.8 10 10.2 H
-ΔV automatic adjustment 4 5 6 mV/section
Output plug: 5.5×2.1 tuning fork, center positive.
Output wire: 2468 24AWG, 1.5 meters long.
Indicator light:
The red and blue lights flash once. After the charger is connected to the (AC) power supply, the red and blue lights flash once, indicating that the charger is initialized.
Steady purple light indicates that the (AC) power supply is correctly connected and no battery is connected.
The red light stays on. Charging is in progress.
The blue light stays on indicating that the battery charging is complete.
The red and blue lights flash alternately, indicating that the battery polarity is reversed.
Flashing red light indicates that the battery is damaged or the interface is short-circuited for more than 6 minutes.
Packing included:
1× Adapter