Features:
-
LCD Liquid Crystal Display: Large LCD display, support battery working
status display, solar panel working status display, mode control
display, load output status and each parameter display, normal and fault
status display.
-
7 Operation Modes: Charging mode, light control mode, light control +
time delay control mode, general control mode, manual control mode,
timing control mode and test mode, the test mode is only for factory
test use.
- 4 kinds of voltages automatic identification: It will automatic identify DC12V/24V, DC36V, DC48V by itself.
-
Large-section Wiring Port: use large-section, large-spacing wiring
ports, can be installed 16mm wire, the wire spacing of 7mm increases the
insulation performance and the reliability of installation, effectively
reduces current and voltage drop while reducing losses.
-
Dual USB Charging Ports: The solar charge controller adopts a dual USB
charging port design, which can charge two devices at the same time, and
supports most of USB port devices, such as mobile phones, tablets, PSP
game consoles, etc.
-
Thickened Aluminum Alloy Heat Sink: The MOS tube is used to lock the
heat sink design, the heat dissipation is more uniform, and there is no
fear of the temperature rise caused by the MOS tube, the powerful heat
dissipation capacity can operate normally in the environment of 55 ℃, at
the same time, it is equipped with functions to prevent overcharge,
overvoltage, DC output low voltage, high voltage protection and reverse
polarity protection, etc.
Specification:
Maximum charging current: 100A
Maximum input voltage of photovoltaic panels: 15V-23V(12V), 30V-45V(24V), 45V-69V(36V), 60V-90V(48V)
Maximum input power of photovoltaic panels: 1000W (12V), 2000W (24V), 3000W (36V), 4000W (48V)
Output voltage: DC12V/24V/36V/48V; DC5V/1.5Ax2USB
Support Battery: Lithium Battery & Lead Acid Battery
Working temperature: -25℃~55℃
Cooling method: heat sink self-cooling
Charging method: Focused MPPT modulation charging
Working mode: seven
Protection
function: prevent overcharge, overvoltage/DC output low voltage, high
voltage protection, reverse polarity protection, etc.
Note:
1.Please
connect the battery to the controller first, and then the photovoltaic
panel to ensure that the battery voltage is higher than (12V battery is
higher than 10V; 24V battery is higher than 20V; 36V battery is higher
than 30V; 48V battery is higher than 40V), otherwise it will cause
voltage Identification error.
Package Included:
1 x Solar Charge Controller
1 x Manual