|
Feature: 1. The product owns advanced equipment manufacturing, high degree of atomization, low energy consumption, high efficiency and easy maintenance.2. The spray gun is made of black material, which is sturdy and durable; the frosted style has an excellent grasping feeling. Using for a long time and you wont feel tired. 3. The nozzle is made of wear‑resistant, corrosion‑resistant, high‑strength stainless steel, and the nozzle can be removed for cleaning and maintenance. 4. The most suitable spraying distance is approximately 200mm. The wide spray range saves you a lot of time and presents a comfortable spray effect. 5. The spray gun is suitable for a variety of different applications, such as automobile, industrial, marine and wood crafts. Choose high quality spray paint,so the quality factor is You can use it at ease. Specification: Item Type: Pneumatic spray gun Material: Stainless steel + black Capacity: 400ml Paint Supply Method: Gravity type Working Pressure: 0.25-0.4 (Mpa) Diameter of Spray Hole: Approx.1.5mm / 0.1in Air Connector Size: Approx. 1.1cm / 1/4 inchPaint Spraying Volume: 435 (≥ml/min) Effective Spray Distance: Approx. 20cm / 7.87in Air Consumption: Approx. 5-10 (l/min) Scope of Application: Latex paint, primer and top coat spraying Instructions: 1. Pour the well-proportioned paint into the paint pot and connect it with the feed joint 2. Connect compressed air to the air inlet connector 3. Pull the trigger and adjust the proper working air pressure (3.5-4.5bar) 4. Adjust the amount of paint and spray width (adjust as needed) 5. Parallel and vertical spray on the clean (spray distance is about 20cm/) The Difference Between Upper and Lower Pots: 1. Lower pot S is suitable for spraying horizontally or less than 45 degrees up and down 2. The upper pot G can be rotated, suitable for 360-degree spraying 3. The lower pot capacity is large, the upper pot capacity is small, according to the use scene to choose Package List: 1 x Paint Spray Gun 1 x Watering Can + Lid Note: Maintenance of Spray Gun1. After each spraying, clean up the excess paint in the pot in time, then wash the inside and outside of the pot with thinner, and clean the outside of the suction tube (only the bottom pot) 2. Pour the thinner into the clean pot and connect Connect the feed connector of the upper gun body to the air source 3. Pull the trigger to spray the thinner until it is confirmed that there is no paint residue in the paint channel, and then take back the excess thinner in the pot 4. Unscrew the cap, moisten the thinner with a brush, and scrub the inner and outer surfaces of the cap, as well as the small holes (if there is dirt in the hole, you can use a toothpick to dredge, but it is forbidden to use metal objects or it will damage the atomization effect) 5. Dip the thinner with a brush, brush the of the nozzle and the small holes, if there is dirt in the hole, use a toothpick to dredge (normal cleaning does not need to remove the nozzle) 6. Wipe the cap and nozzle dry with a clean cloth, and screw on the cap again 7. Finally, wipe the whole of the gun body with a rag 8. It is forbidden to soak the entire gun body in thinner for cleaning, otherwise it will cause the moving parts to become dry and affect normal use! |
