eBay

Vuccum Effecient Room: 270mmx270mmx200mm

Weight: 15KG

Item Package: 460x360x530mm

I. Overview

The seal tester is also called air tightness tester or leak tester. It is mainly used for packaging bags, bottles, tubes, cans, boxes, etc. in food, pharmaceutical, medical equipment, daily chemical, automotive, electronic components, stationery and other industries. Seal test.

The vacuum sealing performance tester is a sealing performance tester with superior performance and high cost performance.

The whole machine has a beautiful appearance. The outer shell is made of 316 high-quality stainless steel. The air sealing pass-through parts are all imported from Germany. The sealing performance is better than similar domestic models. It can maintain the set vacuum value for a long time without vacuum extraction compensation. Vacuum indication control table and timing controller adopt imported joint venture brand, with high vacuum value and timing accuracy and excellent performance.

Comply with national and international standards: GB / T 15171, ASTM D3078 ..

2. System parameters:

1. Vacuum indication range: 0 ～ -90 kba, display resolution 0.2kba. In principle, the external vacuum pump will damage the vacuum pump when it exceeds -75kpa. Please stop immediately.

2. Timing control range: 0 ~ 9999 seconds; 0 ~ 9999 minutes; 0 ~ 9999 hours can be adjusted arbitrarily, the display resolution is 1 second, and the test setting can be 3 minutes.

3. Power source: 110V 60Hz

4. Power supply safety protection: equipped with power supply safety protection measures.

3, the use steps:

1. Check whether the sealing pipeline of the sealing tester is connected correctly, whether the power supply is safe, whether the sealing barrel is placed reasonably, whether the water level is proper when adding water, and whether the test sample is ready, please complete the preparation before the test.

2. Turn on the power and press the power switch to set the test time.

3. Point the air seal stop switch to "pump", press the "air pressure switch", and the vacuum pump starts to work.

4. After reaching the vacuum value, press the "air pressure switch" to turn off the vacuum pump, and point the second switch of the right hand to fully close; the vacuum value will be maintained for a long time. Note: No vacuum can be drawn in the fully closed state; otherwise the vacuum pump will be damaged!

5. Press the "Time Switch" until the end of the test. Observe the tested product.

6. After the test, point the air-tight on-off switch to "deflate". Prepare for the next product test.

4. Matters needing attention:

2. After the test on the same day, it is best to unplug the power cord to ensure safety.

3. Please note! ! ! The test water in the seal tester is best replaced once a week. Do not pour water in the sealed bucket. Be sure to use the container to seal the water in the bucket to avoid deformation and leakage of the sealed bucket. Although the sealed bucket is made of high quality plastic Also plastic, please note! ! !

Accessories:

1. Host 1

2. One vacuum pump

3. Vacuum barrel 1

5. One power cord

6. 1 trachea

7. 1 instruction manual

8. 1 warranty card

9. 1 certificate