Factory Fitted Xenon BALLAST REPAIR KIT BMW E36 E46 E90
OEM XENON BALLAST (controller) REPAIR KIT
The answer if you have a faulty Ballast on a factory fitted Xenon Kit..
FITS D2R & D2S BULBS
COMPLETE WITH...
REPLACEMENT SLIMLINE BALLAST, AND MOUNTING HARDWARE,
OUTPUT CONNECTION WIRE FOR THE BULB AND,
INPUT CONNECTION WIRE FOR THE POWER SUPPLY
Everything you need to replace the original ballast (controller) with our new slimline ballast.
SLIMLINE BALLAST
Replacement Slimline Ballast, measuring only 14mm deep, they are Ideal for the small spaces behind the headlight,
Ballast measures 90mm x 65mm x 14mm
Using only 35w they are save and easy replacement
Operating Temperature -40 / +105
POWER SUPPLY LEAD ..
40cm / 16 inches long
With Specific Ballast
plug on one end and Standard Spade terminals on the other
(This wire can be extended with standard heavy gauge wire if needed)
This is used to connect
the replacement ballast to the original power supply going to the
original Ballast
This wire comes with the fully insulated plug for the ballast and is the same specifications as the standard wires found on our Replacement Slimline Ballast.
Comes complete with the plugs fitted to suit ours and almost all other aftermarket HID kits (Pictured below)
BULB CONNECTION LEAD
This is the lead to connect the replacement ballast to the original bulb as used in most Factory Fitted Xenon Kits
This suits D2R and D2S bulbs
Fully insulated to protect against the high current used in HID lighting
Special fitting plug to suit the rear of the D2R + D2S Bulbs
Each sale is for 1 repair
kit to replace 1 faulty ballast
HID is becoming the new industry standard in lighting for top of the range cars and starting to filter into the motorcycle market.
When the original Ballast goes faulty the original part will cost a small fortune to replace it!!
HID produces much more light while using only 12v - 35w power (standard bulbs are 55w)
Simple job could be accomplished by an experienced DIY'er, or should be only a small charge by an auto electrician !!
Please note it is not quite plug and play but is still easy to fit and will save you a lot of money over replacing the original ballast.
PLEASE NOTE THAT IF YOUR BULB IS HELD IN WITH OTHER HARDWARE THEN THIS MAY NEED MODIFIED OR REPLACED IN ORDER TO ACCOMMODATE THE FITTING OF THE BULB CONNECTION LEAD
Other Accessories or full HID
kits for Cars and bikes are available in our ebay shop please click
here
All our items are covered by a no-quibble 12 months warranty !!
Fitting is remarkably simple and should you run into any trouble then we are only a phone call or email away...
Our technicians have fitted hundreds of these kits and are always available for advise on fitting!
All Items are here in the UK in stock and will be dispatched within 24hours and covered by us under 12month warranty, so please think twice before buying from international sellers!
Picture is a accurate representation but actual item may vary slightly
We are dedicated to ensuring the highest possible quality service to our customers.
Click to expand the tabs below to read more about our policies.