Honda V65 VF1100C Magna, VF1100S Sabre, VF750, VF700 (And Many other Bikes) Clutch or Brake sight glass, Qty 2, like OEM, Sight Glass, press fit, no sealant or epoxy.  This is a replacement sight glass which is like the OEM sight glass (actually plastic) and is sealed by an O-ring when pressed in, also like the original factory installation.  These are not difficult to install but you will need a way to press it into the bore, a small c-clamp works well.  No sealant is required as it is the compression of the O-ring that is the seal, which is like most oem installs.

Note: I have another listing for qty 1 if you need only need 1.

I have no doubt this will fit many brake master cylinders, clutch master cylinders etc, so I have listed the bore dimensions below so you can measure for your application.  I am sure it will fit some Yamaha's, Suzuki's, Kawasaki's and more.

The bore ID that these will press into is .7115 inches or 18.08mm

The depth of this bore is .2170 inches or 5.51mm

There is no lip on these so if your depth is greater, in will just go in further.

Thanks

Customer Confirmed Fit:

It's official! This product fit perfectly into my clutch master cylinder.
My bike is a 1982 Honda V45 Sabre VF750. This is the original master cylinder on the bike. It also looks like a good fit for the front brake master cylinder. Thank you for all the email support and willingness to take it back including return shipping! I gave you the best feedback I could in the short space they give me. All the best, Thanks baxter7092. Sal.