Bypass Module:
The EVO-ALL Data Bypass Module plugs in D2D (databus) right into the starter system for a flawless quick install. It will temporarily override your
vehicle's antitheft key only when the remote start is activated -
leaving the antitheft system 100% functional. The bypass connects to the
remote start through a data connection which eliminates a lot of the
wiring traditionally associated with remote start installation. Unlike
cheap generic bypasses, ours does not require you to leave a spare key
in the car.
FAQ:
** BASIC INSTALLATION KNOWLEDGE REQUIREMENT **
The
installation of this product will require wiring connections. We
provide concise directions with wire colors & locations. It is
important to note at a minimum, a person with a basic to intermediate
knowledge of wiring car electronics should be able to install this
product successfully.
How detailed are the instructions?
Very. The
remote start and interface module both come with installation manuals,
but we've prepared a special step-by-step installation sheet that walks
you through the entire installation.
What other parts will I need?
None. The kit comes
with all the components you will need. The only things you'll need to
provide basic supplies like electrical tape.
How long?
A pro installer can do this in a couple of hours. Your results will vary. Does installing a remote start void my warranty?
Not one bit.
If you properly install any aftermarket product in your car, the dealer
cannot void your warranty simply because that product is there. If
you were to do the installation incorrectly and cause damage, that would
not be covered under your warranty.
NOTE:
Quickly pressing lock 3 times in a row on your OEM remote will activate remote start. This does not include aftermarket remotes.
What is the range of this system?
This system
uses your factory remotes, so the range is determined by the range you
currently get from your factory remotes. Adding the remote start will
not change the range.
My remote does not have a ‘start’ button. How will I activate the remote start?
Pressing the ‘lock’ button on your remote three times in succession will activate the remote start. Remote Start Features:
The RS-160EDP+ is an Add-on remote start system for vehicles
with existing keyless entry. The system uses the vehicle's existing
factory remotes to start the car by pressing the "lock" button three (3)
times (can be programmed to function differently as well)..
- 5 On-Board Relays for Easy Installation
- Selectable Engine Speed Sensing, Tach or "Smart" Tachless Operation
- Programmable Run Time
- "Pit Stop" option allows you to remove your keys, exit the car and leave the motor running.
- Hood Open Safety Circuit. The Unit will not Remote Start if Hood is Open or Ajar
- Plug in Override Switch
- Limited Lifetime Warranty from Omega
| 
