Installation Reference - not to scale - for reference only
(Inverters, batteries, and solar panels are not included in this listing. )

Connection Overview:
The Wind Generator will generate DC power and is able to charge 12V batteries with either a rectifier or our  SolarWind Hybrid RX Charge Controller. Note: the 12V Batteries above are not included.

If your home or farm is connected to the power grid, on windier days you may be able to sell excess power generated by your wind turbine to your utility. At other times when the turbine cannot generate all the power you need, you would buy power from the grid. This concept is called net metering.

Even if net metering is unavailable, you might be able to reduce your power bills by using the electricity generated by wind turbines, and become less dependent on your utility.


Power curve: Performance curve of power output versus wind speed



Since wind speed increases with height, increases to the tower height can mean enormous increases in the amount of electricity generated by a wind turbine.

Generator Specification:

Our's - Aluminum Body, Durable and Long Lasting - Unlike rubber, PVC Rings are much more durable will not harden and crack and cause leaks - Bearing are covered and will not rust / leak	Competitor's - Plastic Body, becomes brittle under the Sun's UV Ray - Rubber ring will harden after approximately 1 year of use and will start cracking and leaking - Bearing are exposed and will rust / leak

Blade Specification:

Adjustable blade degree with included degree adjusters (Shims)

Increase/decrease blade angle by installing degree adjuster under the blades
"+" on the right side = Increase angle = More Torque, Less Speed
"-" on the right side = Decrease angle = Less Torque, More Speed


Below are comparisons between the our blades and competitor's blades

Hub Specification:

Pros - 140mm diameter, 10% larger than competitor's - High blade capacity, allow up to 6 to be installed - Covers the entire face plate to eliminate vortex	Cons - 125mm in diameter - Only allows 3 blades to be installed - Does not cover face plate completely

Mounting Specification:

Ours - Dual Metal ball bearing to prevent vertical vibration - Yaw shaft diameter: 40mm - 3cm of stabilizing distance with 2 bearings - No vibration = Increase in efficiency - Reduction in noise output - One piece design Yaw body provides more stability	Competitor's - Single bearings will not eliminate vertical vibration - Yaw shaft diameter: 35mm - Stabilizing distance effectively shorten to 1.4cm with one bearing (53% reduction) - Vibration will cause bearing to grind on yaw shaft and create a bigger play, which in turn will cause more vibration in a never ending cycle - 2 pieces design Yaw body is less stable

Nose Cone Specification:

With Nose Cone - Smooth Performance Without Nose Cone - Air current spins into tiny vortexes

Rotating blades present the most serious mechanical hazard. The blades may be moving at velocities over 275 miles per hour (440 km/hr). At this speed, the tip of a blade is nearly invisible and can cause serious injury. Under no circumstances should you install the turbine where a
person could come in contact with moving rotor blades.

The installer of these blades is solely responsible for the use or misuse of these blades. We assume no liability for ANY injuries caused by these products.

Monocrystalline Solar Panel 100W 

Specification:

Solar panel generates free energy for many general household appliance. These solar panels also specially designed for use in sailing boats, green houses, cars, radios, recreational vehicles, portable televisions, warning lights, flash lights, garden lights, house light, garage lights and ventilators for rooms and cars. They can also be installed into a grid-tie system.

Comparison Chart:

Monocrystalline Silicon Panels		Polycrystalline Silicon Panels		Amorphous Silicon
Pros	Cons	Pros	Cons	Pros	Cons
15-18% (high) efficiency	More Expensive	Efficiency can be compensated by better utilization of the area available for modules.	12-14% (Medium) efficiency	Most economical	6 - 8% (Low) efficiency
Small Panel Size	Non Rectangular shaped cells	Most Cost effective		Thin Film	Panel size is huge because of low efficiency
Light Weighted (Easy to install)		Small Panel Size			Heavy weighted (Hard to install)
		Light Weighted (Easy to install)
		Rectangular shaped cells

- 36 pieces silicon solar cells
- Enclosed with epoxy and high-quality resin material
- Rain proof, rust proof and corrosive proof, protects against wind, rain, salt air and solar radiation.
- Weather resistant, charge batteries in dry/wet condition

Solar Power Controller 

Introduction:

Many people have asked about power point tracking and whether it has any real advantages. Maximum Power Point Tracking (MPPT) converts the difference between a solar modules rated voltage, (usually 17 volts) and a battery banks charging voltage (up to 14.7 volts) into usable charging current. Often claims are made for up to a 30% increase in charging current. This gain, however, is possible under a very limited set of conditions. The "extra" module voltage is there for a reason: to allow for real world use of the solar module, i.e. the voltage drop caused by the array wiring and other components, including the charge controller, between the solar array and batteries. Also, high ambient temperatures cause the solar module to drop in voltage further reducing this "extra" voltage

Features:

Pulse-width-modulated to keep battery bank at a "float" state of charge
Maximize Efficiency with Max Power Point Tracking (around 30% increase in charge)
Built in diode to prevent reverse flow of current back to the modules
Temperature Compensation
Maximum Output: 10A
Voltage: 12V
Continue Power: 120W
Over-charger Protection
Over discharge protection
Compatible with Hybrid System ( i: solar, wind)
Can use AC Power as source

Specification: