The Handle

for the

older Starbound Observing Chair *

 The hand must be used on this HANDLE for this to work!!!

                        *

( with 1.5" skirts against the vertical tubes (the newer model of this chair has 4" skirts and may have different bolts))

                                                            (A recent buyer offered that his chair...  required longer bolts... but it works well)

                                                                    He said..."

the new version might need longer bolts but the handle will still work fine. 

"

NOW it is easy to control the seat…

(You may see from my feedback...  a person who did not hold onto the HANDLE found it to be ineffective ) <--I suggested that the hand should on the handle for this to work

The Starbound Observing Chair is accepted as one of the best Observing chairs on the market. With a 9" to 32" adjusting range, what else could you want?

 

If you have this chair, you may have discovered as I did, that if you touch the front edge while not sitting on it, the seat is likely to take off towards the bottom, like the bird on a rod toy, bouncy, bouncy, bouncy…'till it has reached the bottom. Yes it is more difficult to adjust its position than is necessary.

NOW it is easy to control the seat… place a finger on the handle as you lift the front edge… raise or lower with ease. tk;)

 

 

Introducing the solution

The Handle

A wire stiffened, webbing strap handle

The-Handle-for-the-Starbound-Observing-Chair

The hand must be used on this HANDLE for this to work!!!

(eyelet holes are 1/4" or 6.5 mm and are abt. 1/4" thick)

(if your chair is not the one in the ad or the back screws are not as above, CONTACT ME PRIOR TO PURCHASE)

 

 

 

 The Handle is designed for the use on the Starbound Observing Chair, Kasner Electronics has no connection to the Mfg. of this  

 an  excerpt from a removed link  weasner.com/etx/showcase/starbound_chair/chair--->  There is one thing that takes some getting used to: many of us tend to move the chair we are sitting on by lifting up on the edges of the seat. You don't want to do that with the Starbound Observing Chair, because the seat will slide. If you are sitting on the seat when you lift it up, the seat, with you on it, will go down. Fast. This could be embarrassing if someone saw you or dangerous to the health of your telescope or your body if you fall. Be certain you tell anyone sitting at your telescope about this. You don't want them sliding down the rails. Also, it is possible to lose your hold on the seat front when lifting it upwards to release the friction on the roller. If you do, the seat will slide rapidly down the rails. So it is necessary to get a good grip on the seat cushion before repositioning the seat. Once you get used to moving the chair by the support structure and lifting the seat front to slide it up or down, you will find it a pleasure to use. I am.


Starbound Observing ChairOceanside sent me a unique add-on for the Starbound Observing Chair that is made by a local astronomy club member. Made by Kasner Electronics, "The Handle" ($9.99) adds a "wire stiffened" strap that is secured to the seat bottom using two of the screws that hold the seat cushion to its frame. The strap goes a long ways to overcoming the problem mentioned above about moving the seat to different heights. You reach behind you with one hand and hold the strap; with the other hand you lift the front of the seat upwards. Then you can easily raise and lower the seat without it slipping out of the hand holding the seat front.

U.S. Patent pending. All rights reserved

(1yr warr.)

Designed and built to last by,

Kasner Electronics

See my other astronomy Items on eBay in my Store