Factory direct, New Production started March 2022.

This is a new, lab tested, proven phased array of TWO 8.9 dBi panels working together in phase via a 50 Ohm high precision divider and 2 short low-loss phasing cables. This is a full kit for the price.

The power divider (OK call it a splitter if you insist) is listed on Ebay by itself. Watch for a listing of the phasing kit alone in case you have some other antennas, or 2 of these already.

Phased Array. TWO Panel Antennas working in PHASE for LoRa, Helium, 900 MHz Band ISM And Data. Rugged. Robust. Long-Term All-Weather Workhorse Provides Years of Service for the popular 902-928MHz band. This Panel Array Provides a Peak Gain Of 12.3dBi With a Very Usable 65-degree Wide and 30 Degree Elevation Beamwidth. Designed In a Compact, Versatile and Light Weight Package to Outperform Competitors at Much Higher Cost. N-type connectors Includes the POWER DIVIDER, PHASING CABLES AND N/SMA ADAPTER. Made In USA.

Designed and fabricated in The USA to exacting standards.

Some installation notes! The spacing is critical, they are 3.5 to 4" apart. Facing the same way its 12.4 dBi peak and 65-67 degrees wide. AIM THEM 35-40 degrees left and 35-40 degrees right, away from each other and you get 105 degrees wide beam and reduced gain to 9.5dBi

This is all true performance not Chinese dBi or fake numbers.

Notes: You can buy a single 12 dBi antenna from any vendor however watch the beamwidth, a True gain of 12 dBi provides approx.. 45 degrees wide signal. And the same 45-degree elevation.

Is this any better than a "12dBi omni?" Yes because an omni cannot ever get over approx. 10.5dBi. And at that point the the elevation beamwidth is VERY narrow approx. 7 degrees. Watch out for the dBiCN (Chinese dB gain!)

ATTN HELIUM MINERS. This is not an OMNI-directional antenna. This antenna is directional and beams a very strong signal in ONE direction 65 to 105 degrees wide and 30 degrees high (vertically). Know what you are buying before you buy. The antenna works perfectly (100% RF test before packing) and if you don't get the results, you expected do not blame the antenna and return it.

SPECIFICATIONS: ELECTRICAL

Frequency Range: 900-930MHz (880-960 reduced gain)

Forward Gain Peak: 12.5dBi

Forward Gain Average: 12.2dBi

Front/Back Ratio: >24dB

Beamwidth @1/2Pwr: 64deg Avg AZ

Beamwidth @1/2Pwr: 30deg Avg EL

VSWR Avg: 1.4:1

Polarization: Linear

Maximum Power: 50 Watts

Connector: Type-N Female (input to the divider via SMA adapter)

SPECIFICATIONS: MECHANICAL EACH Antenna

Dimensions: 9.5x9.5x0.8” 

Dimensions: 24x24x2 CM

Weight Installed: 1.2Lbs

Weight Installed: 0.54 KG

Support Mast Diam: 0.75 – 1.8”

Support Mast Diam: 19-46mm

Wind Survival: 140MPH

Wind Survival: 225KPH

Radome Material: ABS, anti-UV

Back Plate Material: Sheet Aluminum

Mount System: Alum, Plated Steel


Question Recvd but eBay blocks the reply for some reason.

4cammed:

Hi
Can they be tipped down a bit for a lower vertical beam angle?
Also if you set the angle less than the 40 degrees left and right will the horizontal pattern be less with more gain?
Thanks for your help
I’m very interested in this setup.

The safe bet to tilt the beam down would be to tilt the whole mast or pole forward and angle them both down. Its a question to be resolved with the test chamber if  each one gets tilted down and held in same location. I suspect that wont work. Another test is moving the upper one forward some inches.

The 80 degree separation in Azimuth direction stul has them in phase with the benefit being 105-100 degrees wide but reduced to 9 dB. THis was optimised in the test chamber to get to that set up.
Yes any where from straight forward to the 40+ and - left and right varies correctly. So going left and right 20 degrees might go from the designed 12 dBi 67 degree to 10 dBi and 80 degrees.

However then you are in gain numbers like a much cheaper omni. The best ones are just under 10dBi, Over 10 dBi cannot exist. (But they claim whatever they want for sales)

But, the omni will have much less elevation, a thin signal because its putting power out 360 degrees. (instead of just 67 or 110 degrees. The thicker elevation is a good help to canvass more especially if the antenna is up high above the terrain.


Bad Request
Please contact your administrator with the error code: 0.1f7c1ab8.1649374852.a5e91ea