IN STOCK AND READY TO SHIP TODAY!
This is a left handed drop-in assembly made from the highest quality components and cable. Please read the specs.
Please note that this LEFT HANDED version is NOT simply the same as the right handed version with the wiring reversed. It uses CTS Reverse Taper Left Handed Pots, offering the best intuitive setup and performance.
PLEASE READ THE BELOW BEFORE YOU ORDER ELSEWHERE!
WE USE 20 AWG WIRE, NOT THE LIGHTER 22 AWG.
Comes complete with detailed instructions and wiring diagram. All you need to do is solder the pickups and attach the tremolo claw or bridge grounding wire.
These are in-stock and ready to go! I will post by ROYAL MAIL 24 (FREE DELIVERY) on the SAME WORKING DAY of your order if received before cut-off at 2pm. Any custom builds will take a day or two longer and are made to order.
This harness uses high quality branded components:
1x Sprague treble bleed using a 1nF 600V Sprague Orange Drop Capacitor with a 150kΩ Metal Film 0.25W Resistor ±1%
1x Sprague Orange Drop tone cap 0.022µF
20 AWG Vintage cloth covered wiring (not the lighter 22AWG that others use)
3 x CTS 250Ω Reverse Taper Left Handed pots for tone and volume (Logarithmic (Audio) Taper (A)). These have an imperial 9.5mm (3/8") bush diameter. If you currently have metric/import pots, you may need to enlarge your pickguard holes by 1.5mm.
1x Oak Grigsby 5 way selector switch.
1x Neutrik ¼" jack socket with heat-shrunk terminals. We do not use unbranded sockets.
Comes complete with bridge grounding wire already soldered
Options you can request:
- YOU CAN HAVE ANY VALUE OF CAPACITOR AND RESISTOR FOR TEBLE BLEED, OR SIMPLY NO TREBLE BLEED
- YOU CAN HAVE ANY VALUE OF TONE CAPACITOR YOU LIKE - I HOLD MOST VALUES
- YOU CAN HAVE ANY VALUE OF POTS YOU LIKE - I HOLD MOST VALUES
- I CAN CUSTOM BUILD TO ANY SPEC - PLEASE EMAIL
Please note that this is wired for a standard Stratocaster pickguard. If your pickguard has a different layout or spacings, please let us know so we can custom build to that template, or allow more slack/cable between the components.
Please check your jack socket cable tunnel to see if it is wide enough for the socket to be pushed through it. If not, we can supply the jack socket without the wires soldered to it on request.