modname=ckeditor

 

Mini image transmission Mini 5848 5804 OSD assistant image transmission 25/100 / 200mW 

hole distance 20 * 20MM

The Mini5848 series image transmission is a 5.8G ISM band analog image transmission, which has the characteristics of stable output power, long transmission distance, strong power filter, and can ensure that the image has no snowflakes and no horizontal stripes under the maximum throttle. Adopt stackable installation, design 20 * 20MM M2.5 mainstream flight control uses screw holes, image transmission and consistent fixed hole position, perfectly fit the upper part of the flight control, improve rack space utilization and higher safety The tower structure can be assembled at will. The image transmission is the first to use the flight control OSD (TXD) signal to remotely control the transmission frequency of the image transmission. You only need to connect any TXD (serial port transmission) of the flight control to the image transmission RXD (serial port reception) The function of manual key switch. Support PIT mode tuning.

 

Features:

1. The output power is stable and the transmission distance is long.

2. Fast 3-speed power switching, two independent red indicator lights, indicating the current transmit power of 25/100 / 200MW.

3. The frequency point uses 4 * 3 LEDs to display 48 channel values.

4. Support OSD remote tuning and PIT mode tuning (0MW power output can only be turned on in OSD).

5. The onboard power filter isolates the interference caused by the high-power power motor to keep the flight picture clear.

6. Small size, the antenna adopts IPEX interface, which reduces the space occupied by PCB board.

7. Powerful power chip, input up to 27V, output 5V / 1A low ripple, small interference.

8. If the antenna is installed and powered on, the image transmission will not be burned.

9. Small size: 27mm * 27mm, and the mounting hole 20mm * 20mm completely correspond to mainstream flight controllers such as CC3D NAZE32 F3 F4 F7.

10. Light weight: ≤2.4g (excluding antenna and plug wire).

 

Performance:

1. Input voltage: DC 7V-27V

2. Input current: 200MW = 240 MA ± 10MA at 16.4V (4S)

3. Output voltage: DC 5V 1A

4. Power switching: third gear 25MW, 100MW, 200MW

5. Signal channels: 48

6. Frequency point switching: manual button / OSD (simultaneous support)

7. Antenna interface: IPEX

8. Dimensions: 27MM * 27MM * 4MM Pitch: 20 * 20MM, M2.5

Overall introduction:

+ 5V GND VIDEO

Camera power supply (5V)

BAT- BAT +

Input power supply (7-27V)

RXD

Flight control serial transmission

 

Frequency adjustment:

1. Manual adjustment

FR button Switches the frequency.

Short press: switch channels, 4 blue LEDs indicate channels.

Long press (2 seconds): switch the group, 3 green LEDs indicate the group.

There are 48 frequency points in total, the specific channel frequency refers to the frequency point list.

Power Switch：

POWButton The power adjustment。Switch power once per time25MW，100MW，200MW。

 

Default shipment is200MW。

Use pay attention to matters

1.Note that the input voltage is within specialized range and positive and negativePoleIs there，In order to avoid damage to the internal components；

2.If the antenna is replaced, please select the standing wave and the antenna with good gain to obtain a longer transmission distance.；

3.Pay attention to static protection during transportation and installation；

Invoice： MINI 5848 Image transmission transmission module * 1

6P*1.0MM plug cord * 1

 

IPEXDaysLine * 1

'