Skateboard Deterrent for 90 degree walls/benches with 1/2" radius edge.

Product Description

This is a patented 6061-T6 aluminum part typically designed for 90 degree walls with 1/2” radius edge. It is most commonly used on poured concrete as a skateboard deterrent.

Finish: (Standard) Hard tumbled to remove all machined and/or cut edges and with Type-II clear anodized finish. Custom order available: Hard Anodized Finish (call for details)

Outside dimensions: 4" (top) x 2.375" (face) x 2.0" (wide).

Anchoring: Anchored with one of two offset thru holes (pre-drilled) for only ONE SMART PIN PLUS anchor AS SHOWN IN THE PICTURE. Use anchor in conjunction WITH CONSTRUCTION ADHESIVE/EPOXY.

Product Spacing: 18” from end of planters/walls and approximately 36” centers. Do not apply at grout joints.

EPOXY NOTE (EPOXY/ADHESIVE IS NOT INCLUDED) RECOMMENDED TO USE ANY HEAVY DUTY ANCHORING EPOXY OR CONSTRUCTION ADHESIVE).

DRILL BIT NOTE: DRILL BIT IS NOT INCLUDED.