Fast Free shipping from the USA!! 

This one is a resharpened cutter that has not been used 

since it was last sharpened.  Super sharp, still coated 

in plastic. 

You will be happy with it!

Item ....................  Milling Reaming Cutter

Manufacturer ...... Some by Morse Twist Drill Co. some by Cleveland Twist drill co. 

All are made in the US America

Diameter ............. 1.125" 

Shank size ........... 1.121" round with a square drive end

Overall Length .... 11.625 to 11.75" 

Flute Length ........ 5.75" to 6"

Type .................... HS HSS High speed steel Spiral Fluted right hand cut 8 to 10 cutting Flutes

Condition ............ Super sharp, ready to use. 

Just a quick note, hand reamers start out a little bit smaller 

than the actual cutting diameter at the tip then over a short 

distance it tapers up to the full diameter so they start easier. 

If you need to ream full size to the bottom of a blind hole you 

do not want to use a hand reamer. 


You will be happy with it and it will be very well protected during shipping!

If you have a problem with your purchase, please contact me first before leaving feedback, so we can reach resolution promptly and efficiently.  I strive to be honest and reasonable in my business transactions and we have been on ebay since 1999.

Bid With Confidence!

Please take a look at my feedback.  I will do what I can to make sure this will be a positive ebay experience for you. 

Thanks!