One Hella Bulb 90mm Tail lamp
Quality lamp from a quality company at a bargain price
Crystal lens, with easy remove bulb holder.
These have two options for mounting
Option 1
Cut a 80mm hole, locate notch at top of lamp, fit this under hole lip,
push lamp into hole, clip will snap fit into hole. Lamp has a small
flat recess for a screw driver or similar to remove lamp, for bulb
maintenance.
Option 2
Remove spring clip (torx screw), from behind panel screw lamp to body
with three screws similar to torx screw, this fixing method does require
the panel to be moulded to suit this lamp only, we recommend the first
option for mounting.
Dimensions
90mm diameter
length from mounting surface to back of bulb holder 53.58mm
80mm mounting hole required for push fit.
Male spade terminals use female 6.3mm spade terminals
To remove bulb:
Bulb holder uses a securing system similar to Kilner/Grolsch bottle
Unclip metal bar from locater, lift and remove bulb holder from lamp,
remove lamp, remove bulb, refit bulb, refit bulb holder, secure metal
bar to locator on back of lamp.
As a guide:
Mounting position
Rear
min 250mm from ground, maximum 1.5 metre from ground, minimum gap between lamps 600mm
maximum width from outside edge of vehicle 400mm
Naturally this is e marked and ALL the paper work in the world relating to this lamp can be submitted to VCA if required we have a master copy for them to look at, but more often or not it is down to fitter/VCA not understanding the Road Traffic and construction and use law!