6.5" Hoverboard, Self Balancing Electric Scooter, Hoverboard for Kids and Adults


SPECIFICATION

Category: Two-wheel Self-balancing Electric Scooter

Tyre Size: 6.5"

Body material: ABS + PC

Moter power: 300W x 2

Maximum speed: 12km/h (depends on rider's weight, road conditions etc)

Running distance : Approx 10-15KM (About 12.5 Miles, depends on load and terrain)

Climbing capacity: approx 25°(depends on load)

Working temperature: -15℃-45℃

Charging Temperature: 0℃-40℃

Charging time: 3-4 hours

Maximum loads: 200lbs

Waterproofness: Daily life waterproof

Bluetooth: Yes (not include A01)

LED: YES (not include A18)


Package Includes

1 x Two Wheel Hoverboard
1 x Power Supply Charger

Warning

Children under 8 years old need to be accompanied by adult.

Please note

1) Before using, please ensure that both sides of the scooter are at the same horizontal level; and only when the indicator light is green you can step on it and begin to use. If the signal light is red, please restart it and make sure whether the both sides are at the same level and indicator light turns green then use it.

2) Attention for Charging
When the scooter is being charged, the indicator light on the charger is red. If the light turns green, it means the charging is finished. Charging time last about 2 hours. To prolong the battery life and ensure the safety, a long time continuous charging should be avoided


3) To ensure your safety in use, we recommend the use of safety protection equipment, such as helmet, elbow pads, knee pads and etc. please observe the local law when using.

 Warning

It is illegal to ride electric scooters on public roads, pavements, or cycle paths. They are intended only for use on private land with the owner’s permission.

If you encounter these problems:
A.Hover Board not balance or shake itself:
 
Please re-adjust the balance, usually that will work, if not, please contact seller first.
 
B.Hover Board beep beep beep sound or run circle:
 
Please try to reset hoverboard’s system, usually that will work, if not, please contact seller first.

How to reset the Hover Board :

-  First of all：Ensure the board is turned off and make sure that both sides of the boards are on a level surface. If just one green light is illuminated and the other is showing red then it needs rebalancing. （It is very important that you need to turn off the hoverboard before you reset it.)

-  Then , Press and hold the power switch for 15-20 seconds until the indicator light is red, the scooter enter the calibration state.

-  Press the power switch to turn off the scooter.

-  Wait 5 seconds, then press the power switch to turn on the scooter.