THIS LISTING IS FOR THE HOPPER EXTENSION ONLY FOR PHILIPS FULLY AUTOMATIC ESPRESSO MACHINES. IT IS NOT THE ENTIRE MACHINE!!!

To install I prefer to silicon the hopper to the machine being it will give you an airtight bond and also enable you to remove the hopper at a later time without damaging the machine.

All prices are calculated by machine run time and printed at .44mm layer lines to keep runtime costs at a minimum. If you want a smoother finish, you can DM me and I can give you an estimate, but it will cost significantly more and will only be cosmetic.

These HOPPERS are compatible with the below models.

Compatible Models: Philips 800/1200/2200/3200/4300/5400

Specific Part Numbers:
> EP2220/14
> EP2230/14
> EP3221/44
> EP1220/04
> EP3241/54
> EP5447/94
> EP4321/54
> EP4347/94
> EP2231/44
> EP3246/74
> EP3241/74
> EP0820/04

Made From:
PLA: Plant based plastic that is stiff in nature, but brittle if over flexed and can only be hand washed otherwise you risk warping it.

Disclaimer:
3D Printed Parts are not like Injection Molded Parts. The surface will show extrusion rings, artifacts, blemishes and other signs of plastic extrusion. This will occur with any 3D Printed parts using the FDM method of printing as we do. Slanted and curved vertical (Z Axis) surfaces will show more extrusions, artifacts, blemishes and signs of plastic extrusion than flatter parts. This in no way deters from the parts functionality. All parts are inspected prior to shipment.