Replaces OEM #LVA803624


The dip stick is offered in a traditional barb fitting or direct connect fitting. The filter material is installed in the end of the hose directly and can be removed and replaced as needed with tweezers...


ALL DIP STICKS HAVE A BUILT IN DIRT/WATER TRAP IN THE EVENT DIRT OR WATER GET THROUGH THE FILTER MATERIAL/BREATHER THE DIP STICK ITSELF WILL PREVENT IT FROM FALLING INTO THE OIL UNLIKE OTHER VENTED DIPSTICKS, BUT THIS IS UNLIKELY BEING THE BREATHER SHOULD BE INSTALLED HIGH IN THE ENGINE COMPARTMENT KEEP IT AWAY FROM WATER AND DEBRIS...UNLESS YOU SUBMERGE THE MACHINE.


Installation:

  • Ensure your oil in the axle is up to standard in regards to oil level and oil change intervals.
  • Install the dip stick of your choice (BARB or Direct Connect) and tighten by hand until it is secure.
  • Install the hose to the dip stick (Use the hose clamp with the BARB), if using the Direct Connect, you will just need to simply insert the hose into the dip stick.
  • Then insert the hose on the dip stick barb and screw the insert into the dipstick until snug by hand.
  • Finally route the hose with the breather up into your engine compartment and zip tie it to a secure location of your choice.


Barb Kit Includes:

  • 1 - Vented Dipstick with O-ring
  • 1 - Hose Clamp
  • 1 - 24” Hose
  • 1 - Hose Vent
Direct Connect Kit Includes:
  • 1 - Vented Dipstick Direct Connect Fitting
  • 1 - 24” Hose
  • 1 - Hose Vent

This listing is compatible with the below models of Tractor and is replaces LVA803624.

Disclaimer:
3D Printed Parts are not like Injection Molded Parts. The surface will show extrusion rings, artifacts, blemishes and other signs of plastic extrusion. This will occur with any 3D Printed parts using the FDM method of printing as we do. Slanted and curved vertical (Z Axis) surfaces will show more extrusions, artifacts, blemishes and signs of plastic extrusion than flatter parts. This in no way deters from the parts functionality. All parts are inspected prior to shipment.