Bond It Stain Block 400ml Aerosol Spray Paint Covers Water Rust & Mould Marks

Description:
A xylene and lead free, high performance, fast drying, pigmented solvent based permanent stain blocking
coating. CFC Free

Uses
For use prior to redecoration on spot marking, water marks and
stubborn stains.
Suitable for interior use on most building surfaces including brick,
plaster, paint and wood. We recommend the product be tested on
a small inconspicuous area prior to application to determine
suitability. When correctly applied STAIN BLOCK produces a fast
drying, stain block coating ready for redecoration.

Preparation
Ensure all surfaces are clean, dry and free from grease or oil or
any other contaminants that may hinder adhesion. Ensure the
source of the stain has been eliminated. Mask off any areas that
need protecting from spray and repair any holes, cracks or surface
imperfections prior to coating.

Application
1. Ensure good ventilation whilst using this product. Shake can
well until mixing ball rattles and continue to shake for a further
1-2 minutes. Shake frequently during use.
2. Spray directly and evenly over stain in a sweeping motion,
20-30 cm away from the stained area. The multi-directional
nozzle in the horizontal position will produce a vertical line and
vice versa.
3. Apply 2-3 coats dependant on stain. Allow to dry for at least 15
minutes before re-applying. Final decoration can commence
approx. 2 hours after application. Note: ambient conditions and
porosity of substrate will affect the drying times.
4. Store upright.

Drying Time
Do not apply at temperatures below 10o
C or on substrates that
have an RH reading of 90% or above.
Normally STAIN BLOCK should be touch dry after 15
minutes. Drying times are dependant on temperature, moisture
content of the substrate and the area. In optimum conditions
STAIN BLOCK will be ready for redecorating in approx 2 hours.

Coverage
One 400ml can covers 0.75m2 dependent on the porosity of the
substrate.

Container Size
400ml aerosol tin.

Colour
Off-white.

Shelf Life
2 years from date of manufacture.

Storage Conditions
Store in cool, dry conditions away from heat and out of direct
sunlight. Pressurised container: protect from sunlight and do not
expose to temperatures exceeding 50o
C. Always store and
transport in vertical position.

Disposal of Containers
Do not leave empty containers where residue could be
harmful to children, animals or the environment.
Replace lids and remove any containers to a central
disposal point in accordance with local regulations. Do
not pierce or burn canister after use.
Spilt material should be mopped up immediately with
an absorbent cloth and a suitable solvent cleaner e.g.
Bond It uPVC SOLVENT CLEANER.

Health & Safety
Please refer to separate material safety data sheet for full
handling, use and storage instructions. Keep out of reach of
children. It is the users responsibility to determine suitability for
use. If in doubt contact our Technical Department for advice.
Note: this information is for general guidance only, since site conditions
and labour are beyond our control. It is recommended that users make
their own tests to determine suitability.

Specification Summary
Physical Form Off-white viscous liquid
Flash Point Less than -40oC
Solubility in Water Immiscible
UFI

Product Details:
Code: BDSB400
Size: 400ml
Colour: Off White
Barcode: 5060021369680

Package Content:
1x Bond It Stain Block 400ml Aerosol Spray Paint Covers Water Rust & Mould Marks