Bond It Bitubond Range Bitumen Roofing Flashing Primer Solution 1/2.5/5/25 Litre

Description:
A highly penetrative, thin bituminous solution for priming surfaces prior to the application of bituminous

materials

Uses
BITUMEN PRIMER can be used to prime concrete roofs and
floors, cementitious screeds/renders, bitumen felt, mastic
asphalt, weathered corrugated iron and steel. It is the
recommended primer for use with the BITUBOND range of
bituminous roof coatings, flashing tapes or mastics.

Preparation
All surfaces must be structurally sound, clean, dry and
free from surface contaminants such as
grease, rust and dirt. If necessary,
remove any organic growth i.e. moss or
lichen, with a fungicidal wash such as
MOULD STOP. On bare metal a rust
inhibiting product, such as red oxide or
zinc phosphate should be applied and
allowed to harden.

Application
Apply by brush or roller. Using a brush, scrub the primer into
the surface. Ensure that only a thin coat is applied and that
there is no pooling. Priming should extend at least 75mm
beyond the area to be waterproofed. Leave to dry for 2-3
hours before continuing with further work.
With fibre cement or dry rag based bituminous felts, apply
generously to saturate the surface.

Drying Time
Approximately 3-6 hours depending on drying conditions.
May be extended for heavy coatings or in cold weather.

Cleaning Of Tools
Clean with paraffin (kerosene) or Bond It WHITE SPIRIT

Colour
Black in colour.

Container Size
Available in 1L, 2.5L, 5L & 25L metal tins.

Storage Life
Minimum of 5 years from date of manufacture under good
storage conditions in original unopened containers.

Storage Conditions
Store under cover away from sources of heat and ignition.
Keep containers sealed when not in use.

Disposal of Containers
Do not leave containers on site where residue could be a
hazard to children, animals or the environment. Replace lids
securely and remove any containers to a central disposal
point.

Health & Safety
Please refer to separate material safety data sheet for full
handling, use and storage instructions. Keep out of reach of
children. It is the users responsibility to determine
suitability for use. If in doubt contact our Technical
Department for advice.

Note: this information is for general guidance only, since site
conditions and labour are beyond our control. It is recommended
that users make their own tests to determine suitability.


Specification Summary
Type of Solvent White Spirit
Approximate Flashpoint Test Method BS2000:Part 170:1982 [IP170/75 (81)] 40oC
Approximate Specific Gravity 0.90
Approximate Coverage 4-10m2 per litre
(dependant on substrate porosity)
Application Temperature Limits Normally 5oC to 30oC and free
from ice/ water
UN Number 1263
UFI 4A50-Q0G3-U00N-27XE

Product Details:
Size: 1L. 2.5L, 5L & 25 Litres
Colour: Black

Package Content:
Bond It Bitubond Range Bitumen Roofing & Flashing Primer Solution Black

Choose Sizes: 1L, 2.5L, 5L & 25L