Bond It Black Bitumen Paint Weatherproof Roof Protection Sealant Metal Rail 2.5L

Description:
A solvent‐borne, bituminous black paint for external use. When dry it forms an odourless and taint‐free bitumen
film.

Uses
Bond It BITUMEN PAINT is used for the protection of ferrous
and non-ferrous metals, concrete, roofing felt, fibre/cement,
corrugated iron, asphalt and wood, against water. Reduces
corrosion and decay.

Preparation
Surfaces must be clean, dry and free from grease, oil
and any loose material. Remove any
organic growth using Bond It MOULD STOP.
Rust should be wire brushed te remove as
much as possible, any residue must be
primed with a rust inhibitor primer.
Surfaces to be treated must be completely
free of water before applying BITUMEN
PAINT.

Application
BITUMEN PAINT is supplied ready for use and should not
require thinning. Apply at least two coats by brush, roller or
spray allowing each coat to dry before applying the next
coat. Note: At very low service temperatures the coating will
become less flexible, while at high temperatures it becomes
soft and less resistant to degradation by the environment,
and will ultimately flow.

Drying Time
Approximately 6 hours depending on drying conditions.

Limitations
• Do not use in areas where subsequent solvent contact is
likely.
• Do not use for potable drinking water tanks.
• Allow sufficient drying time between coats.
• Bitumen paint may bleed through any paints subsequently
applied over it. Apply a primer recommended by the paint
manufacturer before overpainting.

Cleaning Of Tools
Clean with paraffin (kerosene) or Bond It WHITE SPIRIT.

Colour
Black in colour.

Container Size
Available in 2.5L metal tins.

Storage Life
Minimum of 5 years from date of manufacture under good
storage conditions in original unopened containers.

Storage Conditions
Store under cover away from sources of heat and ignition.
Keep containers sealed when not in use.

Disposal of Containers
Do not leave containers on site where residue could be a
hazard to children, animals or the environment. Replace lids
securely and remove any containers to a central disposal
point.

Health & Safety
Please refer to separate material safety data sheet for full
handling, use and storage instructions. Keep out of reach of
children. It is the users responsibility to determine
suitability for use. If in doubt contact our Technical
Department for advice.

Note:
this information is for general guidance only, since site
conditions and labour are beyond our control. It is recommended
that users make their own tests to determine suitability.

Specification Summary
Type of Solvent White Spirit
Approximate Flashpoint Test Method BS2000:Part 170:1982 [IP170/75 (81)] +40oC
Approximate Specific Gravity 0.901
Approximate Coverage 4-10m2 per litre (dependant on substrate porosity)
Service Temperature Limits -20oC to + 50o
C depending on service conditions
Application Temperature Limits Normally +5oC to +30oC and free from ice/ water
Chemical Resistance Resistant to: most salt solutions, some dilute acids and alkalis, water and alcohol
Not resistant to: oils, solvents, some detergent solutions.
UN Class 1263 Paint
UFI 9250-60DW-X005-3761

Product Details:
Size: 2.5 Litres
Colour: Black
Code: BDB016
Barcode: 5060021360915

Package Content:
Bond It Black Bitumen Paint Weatherproof Roof Protection Sealant Metal Rail - 2.5L