A43 Thread Lock Stud lock Loctite Sealant Adhesive High Strength Thread Glue 50ml

Available Size:
50ml

Description:
A medium viscosity, medium strength, screw and thread locker. Capable of bonding “As Received” parts covered
with a light film of oil. Non‐drip consistency for clean, economic application

Uses:
Bond It A43 THREADLOCK can be used as a locking compound for direct application to lightly oiled components, thus reducing the need for pre-treatment. Also suitable as a standard anaerobic thread locker for fine to medium pitch threads.

Preparation:
Remove heavy oil and grease contamination. Best results are obtained on clean parts.

Application:
Apply sufficient adhesive to coat the threads. The adhesive will start to cure on exclusion of air from the bonding system. Observe handling and strength times stated below.

Bonding Time:
Assuming room temperature is 20oC.
- Handling: < 15 minutes.
- Full strength: 24 hours.

Limitations:
A43 THREADLOCK is designed for metal bonding. Users should satisfy themselves as to the products efficacy when used in conjunction with engineering rubbers and plastics. Not recommended for use with accelerators. The strength of the Thread lock bond will be substantially lower on Stainless Steel. On certain grades it may not work at all without the use of an activator. It is the user’s responsibility to check suitability of this product with their particular application.

Colour:
THREADLOCK is blue in colour.

Container Size:
Available in 50g plastic bottles.

Shelf Life:
Minimum shelf life 12 months from date of manufacture when stored at 20oC in unopened bottles.

Storage Conditions:
Store in a closed upright container between 3 and 20°C in dry dark conditions. At low temperatures the shelf life will be prolonged.

Disposal of Containers:
Do not leave empty containers where residue could be harmful to children, animals or the environment. Replace lids and remove any containers to a central disposal point in accordance with local regulations.

Health & Safety:
Caution: Hydroquinone Monomethyl Ether, Acetyl,
Phenylhydrazone.
Please refer to separate material safety data sheet for full
handling, use and storage instructions. Keep out of reach of children. It is the users responsibility to determine suitability for use. If in doubt contact our Technical Department for advice.

Note: this information is for general guidance only, since site conditions and labor are beyond our control. It is recommended that users make their own tests to determine suitability. 

Specification Summary:
LIQUID
Chemical Composition Modified methacrylic ester compounds
Appearance Blue, medium viscosity, thixotropic liquid, capable of fluorescence
Viscosity 2500 mPa.s
Specific Gravity 1.04
CURED ADHESIVE
Typical properties - tested on mild steel nut & bolt Gap-filling Up to 0.1mm
Break Away Torque 20Nm
Prevail Torque 7Nm
Service Temperature Range -53 to + 150oC
UFI PC90-10X5-R00G-HKNG

Product Details:
Colour: Blue
Code: BIA4350
Size: 50ml
Barcode: 5060021360311


Package Content:
A43 Thread Lock Stud lock Loctite Sealant Adhesive High Strength Thread Glue 50ml