Bond It Chloride Free Low Viscosity Cement Dustproofer & Hardener -25 Litres

 
Description:
A premium grade, low viscosity dust‐proofer and hardener specially formulated to chemically seal concrete and
harden its surface.

Uses
For sealing and hardening concrete floors, both new (minimum 28
days old) and old, in garages, warehouses, factories and
workshops. Bond It DUSTPROOFER & HARDENER penetrates into
the concrete to produce a non-dusting hard wearing surface with
improved resistance to oils, greases and water.

Application
Gloves, boots and goggles should be worn at all times during
application. Ensure all surfaces are clean, dry and
free from oil, grease, paint or polish to maximise
the effectiveness of this product. If in doubt use
Bond It BRICK & PATIO CLEANER to remove any
stubborn stains before washing down and
applying Bond It DUSTPROOFER & HARDENER.
Apply uniformly using a brush at the rate of 3-5m2
per litre ensuring puddling does not occur and
using a firm action to work the product well into the floor. Allow
the first coat to cure overnight before applying a second coat,
which is normally sufficient for most floor types. Floor must be
washed down with clean water 24 hours after application to
prevent formation of efflorescence. Further coats can be applied,
allowing the previous coat to cure before application,
remembering to leave at least 24 hours before washing down.

Overpainting
DUSTPROOFER & HARDENER can be overpainted, however,
the surface must be properly prepared to allow the paint to
wet out and adhere. After applying as the application
section, allow to cure for a minimum of 24 hours. Wash off
and remove unreacted material (this is especially important
for power floated floors) by sweeping or vacuuming the
water away. Leave overnight. Test if the paint will stick in a
small area first to be sure all unreacted material, which stops
the paint sticking to the floor, has been removed. Repeat the
wash down if necessary.
Limitations
Do not use on masonry or coloured concretes. Not
recommended for very dense power floated floors as they
may not allow effective penetration. Do not wash the floor

for at least 24 hours after the final coat is applied.
DUSTPROOFER & HARDENER will not reinstate disintegrating
concrete.

Cleaning of Tools
Rinse equipment after use with plenty of clean water.

Coverage
Approximately 3-5m2 per litre, depending on porosity.

Container Size
5L and 25L plastic bottles. 200L also available on request.

Colour
Clear liquid.

Shelf Life
2 years from date of manufacture when stored in sealed bottles.

Storage Conditions
Store in cool, dry conditions in a sealed container between 5 &
30o
C and protect from frost.

Disposal of Containers
Do not leave empty containers where residue could be harmful to
children, animals or the environment. Remove any containers to a
central disposal point in accordance with local regulations.

Health & Safety
Please refer to separate material safety data sheet for full
handling, use and storage instructions. Keep out of reach of
children. It is the users responsibility to determine suitability for
use. If in doubt contact our Technical Department for advice.

Note: this information is for general guidance only, since site conditions
and labour are beyond our control. It is recommended that users make
their own tests to determine suitability.
 

Specification:
SIZE:25L

Package Content:
CONCRETE HARDENER & DUSTPROOFER / CONCRETE SEALER 25L