New Hunter Ceiling Fan - Replacement "Simple Connect" Remote Control #K5579-02
Replacement for original remote #s: K5579-02
Note: This is the replacement Remote only -
Does not include the Wireless Receiver or Wall Remote Control Holder
- Use this to replace a lost or broken Hunter Fan K5579-02
Requires 3V CR2032 Battery - Installed
Part # K5579-02
FCC ID: IN2TX50
ID FCC: IN2TX50
IC:3558A-TX50
FREQ: 434 MHz
Part #K5579-02 must match for compatibility.
Pairing Instructions:
Note: The remote must be paired before the fan will operate.
- Open the battery compartment and install the battery.
- Turn off the breaker that powers the fan. Leave power off for 1 minute and then turn back on.
- Within 3 minutes, press the pair button on the remote (inside the battery compartment). If pairing was successful, a single beep will sound. Replace the battery door and Phillips head screw.
* If it does not beep, turn off power to your fan, wait 1 minute then try again.
* If fan is a pull-chain model, please make sure that pull-chain control is set to High speed for remote to work correctly.