Bond It 400ml Polyester Anchor Resin Anchor Bond Rapid Set Construction Adhesive

Description:
A polyester resin, 2‐part, rapid curing, chemical anchoring system. Applied in one single action to produce a cost
effective, tough chemical resistant fixing. 

Uses
Suitable for setting bolts, studs, wall ties, starter bars or large
screws, etc into a wide range of substrates. Compatible with
brickwork, concrete, masonry, stone and PFA blocks. Hollow base
materials can also be securely fastened using ANCHOR BOND in
conjunction with a sleeve or sieve.
Chemically resistant, waterproof and vibration proof.

Preparation
Drill a hole to the correct diameter and depth (see chart over
leaf), ideally using a rotary percussion machine. For optimum
results the wall sides should be thoroughly roughened. Clean hole
and remove all dust and debris using a hand air pump or a stiff
rotary brush, if required.
All bars should be clean and free from oil or grease and all flaking
rust should be removed. Threaded rods or studs should be chisel
ended to prevent them being unscrewed from the cured resin.

Application
Screw the mixing nozzle on to the cartridge (hand tighten). Place
the ANCHOR BOND cartridge into the dispensing gun. Squeeze the
hand trigger a few times until material passes through the mixing
nozzle. Allow the material to flow until an even colour is obtained
(normally 5-6 inches). Insert the nozzle into the base of the hole
and extrude material, half filling the hole with resin. Withdraw the
nozzle then insert the fixing into the filled hole, slowly rotating to
fully coat the surface. After application release the pressure from
the dispensing gun. Remove the used mixing nozzle and wipe
away excess material from the end of the cartridge. Once the resin
has cured the fixture can be attached to the fixing and fully
tightened. Do not over pressurise cartridge otherwise leakage may
occur from rear pistons.

Curing
Dependant on temperature. As a guide @ 20oC:-
Gel Time: 5 minutes.
Full Cure: 2 hours.

Container Size
Available in 310ml and 400ml plastic cartridges with special mixing
nozzle.

Colour
Grey in colour.

Shelf Life
12 months from date of manufacture when stored in unopened
cartridges.

Storage Conditions
Store in a dry area between 5oC and 25oC. Keep out of direct
sunlight. Storage at higher temperatures will reduce the shelf life.

Disposal of Containers
Do not leave empty containers where residue could be harmful to
children, animals or the environment. Replace lids and remove
any containers to a central disposal point in accordance with local
regulations.

Health & Safety
Contains styrene.
Please refer to separate material safety data sheet for full
handling, use and storage instructions. Keep out of reach of
children. It is the users responsibility to determine suitability for
use. If in doubt contact our Technical Department for advice.
Note: this information is for general guidance only, since site conditions
and labour are beyond our control. It is recommended that users make
their own tests to determine suitability. 

Product Details:
Code: BDAB380
Size: 400ml
Barcode: 5060021363541


Package Content
400ml Anchor Bond Adhesive Chemical Studding Polyester Resin Mortar Anchoring UK