Here we have a Good Morse taper #5 to MT4 shank sleeve adapterwith a MT4 split sleeve inside it for holding 1.25 inch Bolt thread cutting tapsThis one is NOT for holding NPT pipe tapsThe shank is Morse Taper 5I was not able to knock out the MT4split sleeve, you might need to put some heat to it to get it out withyour drift pin.I do not see a name on itThe tap is a super sharp used plug tap, only has one chipped toothand it's the last tooth so that's good.The first 2 photos are actual photos the other 3 are Stock photos ofwhat the split sleeve tap driver will look like after you take it out.You will be happy with it and it will be very well protected during shipping! If you have a problem with your purchase, please contact me first before leaving feedback, so we can reach resolution promptly and efficiently. I strive to be honest and reasonable in my business transactions and we have been on ebay since 1999. Bid With Confidence! Please take a look at my feedback. I will do what I can to make sure this will be a positive ebay experience for you. Thanks! |