1. Button:
(1) Long press to switch the interface function, no operation within 10s to automatically save
(2) Short press again to switch to the next function display, enter the setting item
and move down
2.“M” Button: (1) Short press to switch the interface.Enter the System Set, short press to confirm.
(2)Long press to enter the System Set, after adjustment, long press to save and exit, long press again to return to the interface
3. Button: long press to quick-shutting,short press to turn on. Short press to switch the
interface function, enter the System Set to move the options.
4.Photosensitive components: Automatically adjust brightness with the environment
5.Chassis bracket
6. Micro interface (Backup)
7. OBD line interface
System switch:
Long press the “M” button to enter the System Set, find the OBD Switch, and change ON to OFF
Quick-shutting:
Long press the button to power off, short press again to power on
Long press the “M” button to enter the System Set, short press to select the menu, short press the “M” button to enter the setting, long press the “M” button to save after adjustment, and long press the “M” button again to return to the interface
OBD FAQ:
1.No function is displayed,no power
Check whether the OBD cable is tight connection,pull down repeatedly to confirm,please try it on another car if still not workable,analysis if it is an error from OBD diagnostic interface,if yes,please repair it and connect the device again.
2.Only the car voltage displays and be automatic power off after 30 second
(1) This product is only available for OBDII and EOBD cars when it is in OBD2 mode
(2) This product OBD2 mode does not support OBD I and JOBD
(3) OBD2 is a car protocol(U.S.A Cars:2003 Other regions:2008)
(4) Please switch to the GPS system for display, and select OFF for the setting item OBD Switch
3.The vehicle speed on HUD is not as same as speedometer’s
(1) Please check that the unit is correct KM/mile MPH, (speed unit switch please refer to the settings)
(2)long press the”M” button into the System Set, Short press select speed error adjustment for fine-tuning(e.g. meter displays 100 Km/h,device shows 102Km/h,Short press button to adjust the parameter value to 98 ).
4. This device cannot auto shut down
(1) Enter the system settings and select the boot method
(2) When the default voltage of the System Set exceeds 0.5V, it will automatically turn on, and the parameter value is adjusted to 0.3V or 0.2V
(Note: Setting the voltage too low will cause the Gauge to keep restarting)
5. Automatic start-up will auto off when step the brake and same situation on Hybrid car in the traffic.
Enter the System Set and select the shutdown method
MODE 0: Judging that the communication conditions meet the preset 5s shutdown (suitable for most models)
MODE 1: Judging that the speed, speed and voltage conditions of the vehicle meet the preset 5s shutdown (suitable for special models)
MODE 2: Automatic start-stop or special for gasoline-electric hybrid vehicles
6. Incorrect time
Clock setting item, adjust to your own time zone