Welcome to Knightshousestore

We are a conpany with more than 10 years ecperience in the priduction of motorcycle accessoruies manufacturers. Our GFYSHIP brand has a high popularity and evaluation.

If you have any product you want. Please contact us and we will help you find it. We also have our own factory. You can customize the products you need. We will bring you satisfied with the service cheap price waiting for you.
   

Product Description

Features:

  • Condition:100% Brand New
  • Color:Black
  • Light Color: Red/Blue/Green
  • 1-6 Gear display

Fitment:

  • For Triumph Speed Triple NON ABS      2002-2004

Instructions Guide:

Disclaimer: Do not attempt to install the product if you don’t have basic mechanical skills. If in doubt, please consult with your dealer.
  • 1. Locate the Speed Sensor coupler. The Speed Sensor (Wheel Sensor) is either on the top of the gearbox or at the front wheel. The 3-pole black speed sensor coupler is usually accessible by raising the fuel tank
Confirmation:
Separate the Speed Sensor coupler (you might need to use a small flathead screwdriver to get the coupler apart). Rotate the front wheel while the ignition is on. Does the speedometer show 0, turn the ignition off and proceed to the next step. Otherwise, try again since you have disconnected something else.
 
  • 3. Locate the ECM (also called ECU) box. It is a flat box with one or more multi-pin connectors under the seat.
  • 4. Find the RPM signal wire in the ECM connector:
  • Sprint RS/ST                      Blue/Black (Solid Blue wire with thin Black stripe)
  •                                             This is the Crankshaft sensor wire. You can tap
  •                                             either at the 2-pole sensor plug or at the ECM.
  • ALL other models             Red (Solid color with no stripe)
  •                                             This is the tacho signal wire.
  •                                             Alternatively, tap the wire from the Crankshaft Sensor
  •                                             (Blue/Purple), either at the 2-pole sensor plug or at the ECM.
  • 5. Peel off the black sleeve (tape), leaving about 3 cm (1.2”) of this wire exposed.
  • 6. Connect the GFYSHIP Black/Green wire to this wire, using the Red wire tap
  • connector supplied.

 

Setup:

You need to setup the module after installation. When ignition is turned on, the
display counts backwards (6 to 1) indicating that the memory is clear.
- Raise the rear wheel off the ground by using a stand, and start the
engine in Neutral. (If you do not have a stand, you may setup the unit while
riding. Find a long, straight road with light traffic.)
- The display will blink “1”. Select first gear, release the clutch, and keep the RPM above idle speed.
The display is blinking faster while the unit is learning the gear.
- When the display shows “2”, select second gear. Repeat this process until all gears are thought (5 or 6). The unit is programmed and should indicate the gears correctly.
Now, when ignition is turned on, the display counts forward (1 to 6) indicating
that it is fully functional.

 

Package Include:

  • 1 x Gear Indicator