Brief Introduce:
It is a brief introduce, all the introduce is for reference only.
The principle is making glue tabs stick on the dent and use tools pulling the tabs and lift the dent.
Big dent needs slide hammer or puller.
Small dent needs mini dent lifter or pulling bridge.
Use different size glue tabs to different dent.
Use hot melt glue gun preheating a few minutes and smear hot glue on the glue tabs and stick on the core of dent.
Wait for 5-15 minutes ( it depends room temperature) and pull it by hand make sure the tabs are strong stick on surface.
Use a slide hammer or dent lifter or any pulling tools lift the dent, try many times.
Drop glue remover or straight alcohol on the glues between tabs and car, remove the tabs and glue.
Check the surface if there still has a dent, use a suitable tabs and repeat the above process.(it could use a line board to check, but experienced users could use it very well)
When there is a bulge (over lift caused), use a tap down tool. Please tap lightly, or it will damage the car.

Hot Melt Glue Gun Specification:
Color: Yellow
Power: 60w
Working voltage: 110V-240V
Frequency: 50-60Hz.
Nozzle material: Copper
Indicator: LED
Plug type: US Plug (please note if it is fit for your country standard)
Stick size: (L * W) 18.00 * 14.50 cm / 7.08"* 5.70"
Cable length: 1.2 m / 3.94 ft
Hot Melt Glue Specification:
Material: EVA
Melt viscosity: (pa.s / 180C) 9-11
Softening point: 80-85 ° C
Curing time: 8-12s
Stick diameter:1.1cm / 0.43 "
Stick length: 26 cm / 10.23 "

Item Include:
1 x T-Bar
18 x Glue Pads
1 x Glue Gun
2 x Hot Melt Glue