Introducing the Tronics Universal Laser Cross Hair for use with CNC Laser Engraver / Cutter / Routers
Now you can add a red laser crosshair laser light to almost any Laser Engraver / Cutter / Router - to help you place the laser head in exactly the right position & to allow for easier alignment.
Our Laser's have an adjustable Focal Length to ensuring that you get the right location every time!
No more Guessing!
No more Wasted substrates!
No more Wasted Money!
Comes with instructions how to setup and configure in LightBurn - So you can find out the offset you need to enter.
you can mount Universal laser crosshair we are selling on the sides or front of your device etc.
Powered by a replaceable CR2032 3.0v Lithium Battery with a switch so you can turn it on when needed and off when not needed.
Comes with the following
- Universal Mounting bracket. (you can apply with double sided tape / velcro not included)
- Industrial Laser Cross Hair Diode already installed with Adjustable Focal Length.
- Switched CR2032 Battery Holder
- CR2032 3v Lithium Battery (Pre fitted)
- Instructions
Fully Tested, manufactured and assembled in the UK (apart from the laser module / battery holder / battery)
Adjustable Focal Length
These are designed for indoor use only.
LASER SAFE USE GUIDANCE - THIS IS NOT A TOY!
A Class 3R laser is low powered. It normally would not harm eyes during a momentary exposure of less than ¼ second. This is within the aversion response, where a person turns away and/or blinks to avoid bright light.
Do not deliberately look or stare into the laser beam. Laser protective eyewear is normally not necessary. A Class 3R laser is not a skin or materials burn hazard.
However, a Class 3R laser can be a distraction, glare or flashblindness hazard for pilots and drivers. NEVER aim any laser towards an aircraft or vehicle that is in motion. This is unsafe and is illegal -- you could be arrested and jailed and or fined.