ANDREWS - 26 SERIES CAMS FOR TWIN CAM
Andrews Products grinds its cams using computer-aided cam design capabilities. This superior technology gives the utmost in both performance and
reliability. Only the best alloy steel billets and heat-treating processes are used. The power in a Harley Twin Cam engine is completely released only when
superior Andrews computer-designed high-performance cams are installed.
- Can be used with stock springs and tappets.
- For two-up touring.
- Bolt-in cam for lower rpm torque on heavier bikes.
- Good power from 1800-5500 rpm.
- Works well with carbs or fuel injection.
- Made in the U.S.A.
NOTE: 59G, 60G and 64G cams are for highly tuned engines and require the knowledge of an expert engine builder for proper setup and installation.
NOTE: All Andrews gear-driven cams require four-gear set for installation (DS-199532 or DS-199538 for 99-06 applications; 0925-0166 or 0925-0152 for 07-14 Twin Cam and 06 Dyna applications).
NOTE: Installer must check coil bind, valve-to-valve clearance and valve-to-piston clearance.
NOTE: Chain Driven Cams: 00-06 model cams use a splined cam drive sprocket. These cams will fit in the 1999 Twin Cam motor, but the splined cam drive
sprocket OEM #25716-99 or DS-199175 must be used. |