The main purpose

Some cars change the LED lights will be installed after the turn signal lamp will flash, or do not flash the new installation error LED lights and so on.In order to solve this problem, the installation of this product can solve the turn signal flash and remove the ED light fault alarm, motor Car fit.

 

 

Installation Notes

*About left and right turn lights is not the same, if the left and right are for LED lights, playing around with each one of the product, such as around the lamp, you can only install two can, but the left front and left left turn signal With a resistor) and the front right and rear right turn signal (with a resistor), are connected with a resistor line. In order to facilitate the installation, it is recommended that each turn signal installed a resistance

 

 

Features:

*Slows down the flash rate when moving from bulb to LED indicators

*Adapt your existing relay unit instead of replacing original equipment.

*One resistor is required per indicator on most bikes, but some bikes might require

*more than one per indicator depending on the original wattage and other aftermarket LED indicators/resistors fitted.

*Bullet connectors for easy installation

 

 

Package includes:

4x Motorcycle Load Resistor