Feature:

1. Mainly Usage: This high frequency induction heater can be used for heat treatment of small parts such as quenching and annealing of DIY players
2. Metal Melting: The high frequency induction heater can be used with graphite crucible for melting gold, silver, copper, aluminum and other metals
3. Even and Fast Heating: The induction heating machine heats evenly and quickly, very convenient and practical to use
4. Good Heat Dissipation: The induction heater adopts oversized PCB layout design and heat sink, with cooling fan interface, has good heat dissipation and high power
5. Long Time Usage: The high frequency induction heater can work continuously under good heat dissipation condition, and can be used for discharge, for Marx generator, high voltage inverter power supply, etc.

Specification:

Item Type: High Frequency Induction Heater
Material: ABS, Brass
Usage: Industrial quenching, annealing
Basic Parameter:
Host Input Voltage: DC48V
Pump Input Voltage: DC12V
Host Maximum Power: 2500W
Host Maximum Current: 50A

Note:

1. The power of induction heating is very high. In addition to the heat generated by the PCB board and electronic components, the heat generation of the heating coil is also very large. In order to avoid the heating coil burning and affecting the entire system, please be sure to match the heating coil cooling water pump.
2. Pay attention when using the switching power supply, because the high power switching power supply generally has a slow start function, which the output voltage rises slowly at the beginning. If the induction heating circuit is turned on before the voltage rises to 11V, the circuit will not vibrate due to insufficient voltage, and the MOS tubes on both sides will turn on at the same time and burn the components. So be sure to make the switching power supply voltage stable before connecting to the induction heating circuit. An air switch can be connected between the power supply and the main board, and the air switch can be turned on after the switching power supply is powered on and stabilized.
3. This circuit has very strict power requirements. The 12V power supply must use a power supply greater than 500W, for 24V power supply must greater than 1200W, for 36V power supply must greater than 2000W, and for 48V power supply must greater than 2600W (recommended operating voltage is 48V).
4. No matter it is used at any voltage, as long as the working current is lower than 50A, the circuit will not burn out, so a 50A fuse can be added for protecting the circuit during high power operation.
5. It is inevitable to generate heat during high power operation, so you should use a fan top blowing to effectively dissipate heat while working.
6. The working voltage must not be lower than 12V.
7. When the heating machine is working, the heating will generate a high amount of heat, and water cooling must be used to cool the heating to avoid damage to the motherboard due to high temperature.
8. The power input terminals are marked with positive and negative poles, do not reversely connect them.
9. The heating coil may be deformed during transportation, resulting in a short circuit between layers. Please separate before connecting to the main board, otherwise it may overload and burn the main board.
10. Do not power on with no load (here no load means that the output is not connected to any load, the heating coil does not heat the object is not counted as no load), otherwise the board will make high frequency noise, instantly burn the motherboard, and completely scrapped.

Package List:

1 x Host

1 x Crucible Liner

1 x Crucible Shell

1 x Hose

1 x Water Pump

1 x Heating Copper Tube

Note: