Feature:

1. HIGH EFFICIENCY: The resin has good fluidity, can effectively improve the printing speed and success rate, and the strength is enough to withstand accidental drop.
2. EASY TO CLEAN: The resin has very little smell during 3D printing, after printing, only use an airgun and spray to clean it, so as to avoid sticking to the pan after printing.
3. FOR 3D PRINTING: This UV resin has volume shrinkage during curing, which brings glossy and high resolution to the printed model, is a good tool for 3D printing.
4. GOOD COMPATIBILITY: The rigid resin is suitable for DLP LCD 3D printers, which has good compatibility, and supports 8K, especially for small and half length models.
5. WIDE APPLICATION: The 3D printing rigid resin has a wide range of applications, with a capacity of 1000ml, used in desktop models or industrial parts, convenient and practical.

Specification:

Item Type: 3D Printing Resin
Capacity: 1000ml
Applicable Light Source Wavelength: 365-405nm
Underlayer Exposure Time: 20-30S
Bottom Layers: 6 layers
Regular Exposure Time: 1.5-3S
Density: 1.10-1.12g/cm³
Viscosity: 260-350mPa·s (at 25℃)
Bending Strength: 47-50Mpa
Tensile Strength: 48-54Mpa
Hot Deformation Temperature: 85℃
Glass Transition Temperature: 100℃
Shore Hardness: 82D
Fracture Elongation: 8%-12%

Note:
1. The ambient temperature is 20-30 ℃. Do not print in the window or other environment exposed to ultraviolet light and try to isolate children and pregnant women.
2. Shake the resin for one to two minutes before use to prevent the components from settling.
3. It is recommended to wear nitrile and protective mask when using, and keep indoor ventilation. Those who are allergic to acrylic acid should be cautious.
4. The residual liquid on the of the printed resin parts should be cleaned, and the cleaning process should not exceed 1 minute. If the cleaning time is too long, the structural performance of the resin parts will become worse.
5. Where the pores and other details are not easy to clean, ultrasonic or syringe and other auxiliary tools can be used for cleaning, and it is not advisable to clean the model too many times. The cleaning model with impure detergent will to whitening and unclean washing. The specific cleaning time shall be subject to the effect that there is no viscosity on the of the resin part and no residual resin in the pores.
6. After cleaning, drain or blow dry the residual detergent with a hair dryer, and place it under ultraviolet light or sunlight, and all parts of the model should be evenly exposed to the light, until the of the nail scraped resin parts feels dry and the hardness is enough, the residual resin solution on the skin can be cleaned with detergent, and try not to touch the washed resin residue solution with your hands.
7. If you accidentally let the resin enter your eyes or mouth, please wash it with plenty of water immediately. If you feel unwell, please consult a doctor immediately.
8. Product contact with skin may cause maladjustment or allergic symptom. The product may cause serious discomfort if dropped into the eyes. Prolonged exposure to the product environment may cause poor breathing. Eating the product by mistake may cause respiratory discomfort or allergic symptom. Please do not let children contact this product.

Package List:

1 x Resin