- The Spark Plug Wire Remover Tool makes changing spark plug connectors possible without removing the intake manifold or any fuel lines and rails; Easily fits on the end of the rubber boot to unlock/lock the boot and properly remove the plug wire without damage.
- Compatible with Volkswagen and Audi vehicles with standard prong plug caps on each side (not recommended for non-VW/Audi plug leads); For Volkswagen New Beetle 2.0 engine AZJ (AEG), for Golf IV & V 1.6 engine (AVH), 1993-2005 2.0L 4 cylinder (AZG), 1998-2006 1.8L 4 cylinder (BBW), 2006 and later 2.0L 4 cylinder turbo (BDC); for Audi – 1998-2006 1.8L 4 cylinder turbo (BEV), 2006 and later 2.0L 4 cylinder turbo (BGD).
- No need to remove the intake – Simply push the spark plug boot removal tool down, turn, and pull; Perform spark plug change when engine is cold to prevent the heads from stripping; After pulling the plugs, we recommend applying lubrication to make the job easier; When installing wires, refrain from pushing too hard without the tabs aligned on the tool to prevent the boot end from spreading and getting stuck.
- 12.8-inch (32.5cm) overall length.Angled shaft allows access to deep plugs in hard-to-reach areas.
- Handle constructed from hard plastic for comfort, less user fatigue, and more productivity; Shaft and boot end constructed from stainless-steel for maximum strength and longevity.