The TS-990 series is equipped with a dual receiver that supports simultaneous reception of two waves in different bands. The main receiver has a full down conversion configuration and uses a newly developed mixer and narrowband roofing filter to achieve performance in the 3rd order intercept point +40dBm class.
Achieved the best basic reception performance in the series. In addition, it is equipped with three 32-bit floating point calculation DSPs, and uses advanced technology such as unique IF AGC control realized with advanced DSP technology to achieve the high-dimensional reception performance that is truly required in HF equipment.
The final amplifier uses a 50V drive POWER MOS FET, allowing stable operation with low distortion even at a high output of 200W.
Furthermore, the world's first *1 dual TFT display provides comfortable visibility and operability, including band scope function, audio scope, and S meter display.
●Standard power supply voltage: AC 100 V (50/60 Hz)
●Power supply voltage range: AC 90 V to 132 V / 180 V to 264 V
●Maximum power consumption during transmission: 720 VA or less
●Power consumption when receiving (no signal): 120 VA or less
●Operating temperature range: 0℃~+50℃
●External dimensions excluding protrusions: W 460 x H 165 x D 400 mm
●External dimensions including protrusions: W 460 x H 182 x D 449 mm
●Mass: Approximately 24.5kg
●Rated transmission output CW/SSB/FSK/PSK/FM (AM): 200 W (50 W)
●Modulation method: SSB: Balanced modulation, AM: Low power modulation, FM: Reactance modulation
The power supply unit (switching power supply) built into the TS-990 supports AC100-240V, 50/60Hz.
This is the common specification for models for all markets.
Certification tests for radio equipment are conducted under the following conditions.
- ... Therefore, please note that use of AC200V with the domestic model is outside the scope of the product specifications and is not supported.
*The AC power cord included with the domestic model is for AC100V only. Due to safety standards, this AC power cord cannot be used with AC200V.
※ Returns other than initial defects will not be accepted.
The speakers shown in the fourth photo and dimension diagram are not included.