Features:

1. Multiple input options (input via JAMMA slot, VGA connection, RGB-S connection, and L/R audio input)

2. Slot 1 is automatically enabled and plays when first powered on.

3. Both slots are powered on at the same time

4. Switcher routes +5VDC, +12VDC and -5VDC

5. Switcher routes service and test button functions and up to 4 firing buttons per player

6. Quick and easy setup

Introduction:

1. You can plug 2 different Jamma PCBs into one cabinet and select the game you want to play by pressing the switch control. Installation is simply a matter of plugging the PCBs into your existing Jamma wiring harness. It's easy to install and works perfectly.

2. Easily install two different JAMMA (or non-JAMMA using a JAMMA adapter) PCBs into a single JAMMA cabinet! This 2-in-1 JAMMA switcher board is easy to install and works with a quick push of a button. Includes wired switching capability.

3. This 2-in-1 switcher board operates differently than the larger 6-in-1 switcher boards. First, both slots (1 and 2) are energized at the same time, unlike 6-in-1 switches that only energize one slot at a time. This provides seamless and fast switching between the two installed boards. This is also required if installed in a public game room (so if a second game board is selected, the customer does not have to wait for the second game board to power up and self-test ...... the game is already up and ready to go)

Directions for use:

1. Install the 2-in-1 Switcher PCB into a JAMMA-ready arcade cabinet (preferably on the floor of the cabinet if possible)

2. Connect the 2-in-1 Switcher PCB to your JAMMA cabinet connector.

3. Install your other JAMMA PCB (or a non-JAMMA PCB using a JAMMA adapter) into one of the open 2-in-1 switcher PCB slots (the slot furthest away from the JAMMA connection is slot 1 / the closest is slot 2). Insert the Jamma board with the front of the board (with the monitor port on the front) to the front of the switch, which has two VGA input ports.

4. Open your cabinet and enjoy!

Notes:

1. This switcher will not video switch with the 400-in-1 Pandora V2 PCB board that uses VGA video.

2. In order to use this board, VGA video needs to be switched manually using the VGA switch box.

3. Short video needs to be switched on a separate switch, all other functions will switch normally. If you are using a CGA tube monitor then there is no problem.

4. Monitor: If you are using a CGA monitor, then you just need to connect the monitor from the Jamma harness; if you are using a VGA monitor, then you must set your Jamma board to VGA and then plug the VGA ports of both Jamma boards from the board to the VGA input of the switch using a male to male VGA cable.

Package Includes:

1*Switcher

1*Remote Control

1*Receiver