01 Compatibility

B — Xinput mode (Windows/Steam)

A — SWITCH mode

X — PS3 / Dinput mode (Raspberry Pi / Android)

Y — PS4 mode (Compatible with PS4 games on PS5 console）

RT — KEYBOARD Mode

Input Mode

To change the input mode, hold one of the buttons(as shown above) as

the controller is plugged in.

Tips：

This product defaults to Xinput mode ， Input mode is saved across

power cycles.

If there are games that do not compatible the above input modes , you

can enter the Web Configurator to modify them for normal use.

PS4 Mode

About PS4 8 minute disconnection，there are two ways， one is insert a dongle or a officially authorized PS4 wired controller to the EXT.port，We don't have a recommend one，there are too many choices，maybe you can discuss with other nice players in haute42 group，Ficial Website：www.haute42.com

D-Pad Modes

You can switch between the 3 modes for the D-Pad while the controller

is in use by pressing one of the following default combinations:

● BACK + START + DOWN = D-Pad

● BACK + START + LEFT= Emulate Left Analog stick

● BACK + START + RIGHT= Emulate Right Analog stick

D-Pad mode is saved across power cycles.

Invert D-Pad Y-axis

A toggle is available to invert the Y-axis input of the D-pad, allowing

some additional input flexibility. The default hotkey to toggle is to press

● HOME + START + RIGHT = Y-axis inersion

This is a temporary hotkey mapping for this feature, so keep an eye on

updated releases for this to change.

SOCD Modes

Simultaneous Opposite Cardinal Direction (SOCD) cleaning will ensure

the controller obeys certain directional input rules when sending inputs

to the computer/console. Users can choose 1 of the 3 SOCD Modes

while the controller is in use by pressing one of the following button

default combinations:

● HOME + START + UP = Up Priority mode

Up + Down = Up, Left + Right = Neutral (Standard stickless behavior).

● HOME + START + DOWN = Neutral mode

Up + Down = Neutral, Left + Right = Neutral

● HOME + START +LEFT =Last Input Priority (Last Win)

Hold Up then hold Down = Down, then release and re-press Up = Up.

Applies to both axes.

The selected SOCD mode is saved across power cycles

TURBO

First Time Setting

1. Enter the web configurator page

2. Configuration > Add-Ons Configuration > Turbo > Enable

3. Type 14 below Turbo Pin, press Save at the bottom of this page，

then reconnect this board to use turbo function.

Turbo Setting

Hold TURBO，then press the button which you need to be set for turbo

function，then this button will be continuous sending while you press

it,to cancel this turbo key，just repeat the privious step.

The turbo key that set will be cleard when power off.

These keys can be set as a Turbo key: A / B / X / Y / LB / RB / LT / RT