Features:
Before energizing, block the hole of the solder suction head with your finger, press the button of the solder suction head, if the piston is not easy to pop out in place, it means that the seal is good.
If the tin suction head is worn out, it should be replaced with a new one to ensure that the piston of the tin suction device is well sealed.
The solder paste is impregnated with a little rosin before it comes into contact with the solder to improve solder fluidity.
The head contacts the pad a little longer, when the solder melts, draw a circle clockwise with the solder pin as the center, and then press the tin suction button.
Made of high-quality plastic material, durable and not easy to damage, it can be used for a long time.

Operation Manual:
1. Press the piston of the tin suction device down until it locks.
2. Heat the solder joint with an electric soldering iron until the solder melts.
3. Take off the soldering iron, quickly put the tin absorber into the resistance paste solder, and press the button on the tin absorber.
4. If it is not clean once, it can be repeated many times.

Specification:
Material: plastic
Size: 0.79*1.18in/2.0*3.0cm
Color: white
Application: Suitable for extended gray large tin suction device

Package Includes: 1pc

Notes:
Please allow slip errors due to manual measurement.
Colors may vary slightly for different monitors.