Magic Vanity & Wall Sealer Trim
7/8in x 11 Feet Roll (2.2cm x 3.3m) - New longer version. An inexpensive way to waterproof and beautify the caulk joint at vanity and wall.
Vanity and wall sealer trim provides a water-tight seal, is mildew resistant, and will not crack or discolour.
Features:
- Flexible
- Adhesive-Backed
- Peel and Stick Application
- Easy to install
- White in colour
Surface preparation:
Magic sealer trim can be applied over existing grout and properly sealed and cured, non-silicone caulk. Remove loose, protruding, or mildewed caulk. Thoroughly clean surface of vanity and wall with an all-purpose cleaner, paying special attention to areas near faucet and soap dish; rinse clean. Use rubbing alcohol for final cleaning of surfaces to which Sealer Trim will bond. Allow surfaces to dry thoroughly.
Application:
- Measure the length to be covered and cut Sealer Trim to that length.
- Pre-bend Sealer Trim by folding it at the score line to form a 90° angle. Maintain fold during installation.
- Peel the first few inches of backing paper and begin to press the folded strip at one corner into the joint where the vanity meets the wall. Avoid stretching product during installation. Pressing the strip firmly against both vanity and wall, continue to peel the backing paper along the length of the surface.
- After installation, run your fingers firmly over all lengths to ensure good adhesion and watertight seal. Do not allow water to contact the strip for 6 hours following installation.