"Pattern" Henderson T bar locking handle - Finished in silver.

Has 36mm spigots and a long 75mm shaft  - These are the "Actual" spindle and spigot lengths NOT measured from back of face plate!

50mm spigot spacing.

The 7mm square shaft is set "diamond" to the handle and is offset 45 degrees (as opposed to square in relation to the handle at 90 degrees.)

These are UK stock and are sent same day or next day from the UK depending on time of order. Check the feedback score!

Please note: This is a generic “Pattern” part and is made to replace similar locks for the Henderson range of garage doors. The mounting screws may need to be cut down on some styles of door and the shaft can be cut down to length required and therefore is NOT drilled on the end.  The pack of screws, washers and split pin should cover all requirements. If you are trying to fit this to another make of door then the fittings may not be suitable, please ask at time of order and I will try and "tailor make" you a set of fittings.