eBay

25 Pieces
1/4" x 3-1/4" Phillips Flat Head

410 STAINLESS STEEL FEATURES AND BENEFITS

Stainless steel finish provides a decorative aesthetic and superior corrosion resistance.
30% lower installation torque and 20% more holding power eliminates head snapping.
Finished head gives a low, uniform profile and aesthetic appeal.
Close-to-edge placement. No expansion or outward pressure allows installation near a concrete’s edge without cracking.
Easily reversible and removable. No inserts required.
Made in the U.S.A.

BENEFITS

Patented Advance Threadform provides superior pull-out performance.
Application of coating adds extra corrosion protection.
30% less installation torque; 20% more holding power.
Reversible and removable.
Building code approved.

FEATURES

410 grade stainless steel with C4 top coat for added corrosion protection
Suitable for concrete, brick and hollow-block applications
Suitable for some preservative-treated wood applications
Available in lengths from 1 1/4" to 4"

MATERIAL

Heat-treated 410 stainless steel

Caution: Oversized holes in the base material will reduce or eliminate the mechanical interlock of the threads with the base material and will reduce the anchor's load capacity.

Drill a hole in the base material using the appropriate diameter carbide drill bit as specified in the table. Drill the hole to the specified embedment depth plus 1/2" to allow the thread tapping dust to settle and blow it clean using compressed air. Overhead installations need not be blown clean. Alternatively, drill the hole deep enough to accommodate embedment depth and dust from drilling and tapping.
Position fixture, insert screw and tighten using drill and installation tool fitted with a hex socket or phillips bit.

Preservative-treated wood applications: Suitable for use in non-ammonia formulations of CCA, ACQ-C, ACQ-D, CA-B, SBX/DOT and zinc borate. Acceptable for use in exterior environments. Use caution not to damage coating during installation.

Call or email us for all your Simpson Strong-Tie needs. We are one of SW Florida's LARGEST supplier!!

IMPORTANT INFORMATION REGARDING STAINLESS STEEL TAPCONS

The 410-grade stainless steel will stick to the magnet even though it is stainless steel of a lower grade.The 410-grade stainless steel resists corrosion in dry atmospheres, freshwater, acids, mild alkalies, food, hot gasses and steam. Tapcons are coated with Climaseal®. This coating, when applied on top of 410 stainless steel, gives these concrete screws superior rust resistance. This coating is called a thermosetting polyester coating and is a result of a three-step process. First, the concrete screws are cleaned and pre-treated and a zinc overcoat is mechanically applied. Second, a first coating of Climaseal® is applied by dipping each screw into the liquid then spinning each screw. This provides consistent coverage and quality. During the third and final step, the screws are dried in a furnace before the second coat of Climaseal® is applied.

410 Stainless Steel tapcons undergo a hardening process which gives them magnetic properties. They are then coated with an extra layer of protection. Many have asked and these are in fact stainless steel.