|
DESCRIPTION:
- The induction wire is in full contact with the spark plug
- The maximum speed is 30000
- The maximum timing time is 999999
- Automatic recording of maximum speed
- The default time of cleaning air filter is 20 hours, and it is 20 hours after reset
- The default time for cleaning the oil filter is 30 hours, and it is 30 hours after reset
- The setting range of maintenance time is 0-1000 hours
- Use for:Motorcycle,ATV,Marine or any gasoline 2/4 stroke
- Speed type:
- 1P1R=1 spark per revolution;
- 2P1R=2 spark per revolution;
- 3P1R=3 spark per revolution;
- 4P1R=4 spark per revolution;
- 6P1R=6 spark per revolution;
- 8P1R=8 spark per revolution;
- 3P2R=3 spark per 2 revolution;
- 5P2R=5 spark per 2 revolution;
- 1P2R=1 spark per 2 revolution;
- Maintain Reminder function: the user can press the key to enter the setting mode under the maintenance reminder interface, and then the product can be operated
- When the cumulative working time reaches the user-defined setting time,The product will prompt the maintenance reminder
- The timing mode with reminder is countdown
- The product has the function of total timing, the total timing time cannot be cleared
- The product has the functions of single time cumulative timing 1 and single time cumulative timing 2. Long press the key in these two interfaces 2 seconds can clear the current timing time.
Features:
- No power required-included CR2430 battery sealed inside
- Works on any gas engine
- Indicates operation in PRMs and Hours
- Resettable for current JOB time;total time not resettable
- 9 programmable firing patterns
- Record max RPM of engine
- programmable maintenance interval timer (SVC)
- programmable Clean air filter timer
- programmable CHG oil timer
- Easy installation - includes double sided tape,screws,and fasteners
- Waterproof-IP68 Rating
hour meter installation method:
-
Select a contact point from the inductive pick-up line to the spark plug.The motorcycle is installed in the frame node on both sides of the steering column belt or screw on both sides.Note: do not install the product in an environment above 125 degrees
- Mounting holes drill 1.750 inch apart center to center ,Drill two holes 7/64 inch. Don't use the oil pressure Drill holes in the crankcase of recoil cylinder, oil tank and engine
-
Wrap the other end of the signal wire around the spark plug wire for 3-5 turns and use a cable tie
Tie the end. If the installation is correct, the hourglass on the LCD will flicker and automatically
Start timing.
PACKAGE LIST:
- 1 x Hour Meter with Cable,2 x Screws，2 x Plastic cable ties, as per photo
|