So you completed that Blink Project on your UNO and now you are ready to move on to something a little more exciting. Our Arduino ProMini comes with a miniature form factor allowing you to put your newest creation almost anywhere. If it ran on your UNO, you can run it on our ProMini. And at the price why not pickup a couple of them?
The included CH340G USB-Serial programmer has been removed and is a separate component so you have less weight and space requirements when using this device.
If you already have a USB-TTL UART and just would like the ProMini check out our other listings in our Store.
If you would like more than one ProMini we also sell this kit with 3, 5, or 10 ProMini's and the CH340G Programmer.
ProMini Features and Specifications
Atmel ATmega328 microcontroller
5V DC logic level operating voltage
Most flexible input voltage available (via RAW pin) 3.3 to 12 VDC
Supports external 9VDC battery power
14 digital input/output pins
6 PWM output pins
8 analog Input Pins
32KB flash memory
16Mhz clock speed
33.3 mm x 18 mm (1.3 in x .7in)
Bootloader pre-installed
"Blink" sketch pre-loaded as default and fully tested at factory
Supports serial monitor in Arduino IDE
Header pins included (as shown in ProMini photo)
CH340G Features and Specifications
Supports Windows 8, 7, XP, 2000
Supports Mac
Supports Linux
Cable included as shown in top photo
Includes DTR pin so that manual resetting of the ProMini is unnecessary. The process is simple and automatic.
Cable colors vary, but all include 5 female/female headers for easy connection.
Buy with confidence from a USA seller and avoid the delivery delays when ordering from China!