Package Includes:
2 Pieces 2'-0" (24") Blue LED strip lights. 72 Big & Very Bright 5050 SMD LEDs. 36 LEDs on each strip.
On a white background.
Compared to other sellers, our
LED strips use larger and brighter 5050 SMD LED chips. Be careful and
look closely. Some sellers use smaller 3528 LED chips but their photos
show the larger 5050 LED chips. 3528 LED chips have a single light
emitter built in whereas our 5050 LED chips have 3 light emitters built
in.
Features:
- Size: Each strip is 2 feet long x 3/8 inch x 1/8 inch
(Length x Width x Height)
- Each light strip has 36 large 5050 SMD LED light chips (2 strips = 72 LEDs total)
- Each LED chip has 3
light emitters
- 72 LED chips x 3 light
emitters = 216 light emitters
- Highest quality, brand
new, and never used
- Thin & flexible
- Waterproof, heat &
vibration resistant
- Adhesive backing, simply
peel and stick to the desired location.
- Emits a 180 degree,
bright, pure color glow
- Positive and Negative Wire
attached on one end
- Can be cut between
every 3rd & 4th LED. Cut between copper dots. Leftover strips can be
reused. Just trim off clear rubber and solder on new wires to the
copper solder pads.
- Low current consumption
- Wires can be connected to
any 12v source on the boat.
- Easy to install
- 100% satisfaction guarantee
Some important guidelines for installing LED strips:
- These
strips are very flexible. However, you should not bend them at sharp
angles or you risk damaging the solder connections that hold the LED
chips to the circuit ribbon inside. This type of damage isn't covered
under warranty.
- Do not bend the LED strips "against the grain" or along the short edge.
- Make
sure the power going to the LED strip is turned off when you charge
your boat's battery. LEDs are very sensitive to over-voltage and will
burn out instantly if too much voltage is applied. Battery chargers
often give a voltage spike when initially connected to the battery.
LEDs are safe up to 14.5v.
- Make
sure the mounting surface is thoroughly clean. If the LED strips are to
be applied to a smooth, painted surface, rough up the surface first for
best adhesion. Depending on the mounting surface, you may need to use a
stronger adhesive. The most common is 3m double sided body molding tape
available at most auto part stores.
Gallery:
Can
be cut between the copper solder pads as shown below. Solder pads are
spaced at every 2 inches. To reuse leftover strip, trim off clear
rubber coating over the solder pads and solder on wires.
Rolls
are shipped on a plastic reel, in anti static bag as well as a bubble
lined package for safe shipping. LED strip is tested immediately before
shipping.
Example photos:
Thanks for looking!!! :-)
© 2006 Fyre Flys™
All photos are property of Fyre Flys Inc.
Copying photos is prohibited.
|
|
|
|