SEATS OR SWITCHES ARE NOT SUPPLIED THIS IS THE WIRING LOOM ONLY

If you require switches then click here for a kit

Land Rover Defender Td5 made from 2002 until 2006 wiring loom with IGNSENS to suit YUG 102430 & YUG 102440 heated front seat switches fitted with OEM Land Rover heated seat connectors.

The illumination and negative cables are 500mm long so are suitable for splicing into an existing switch.The power in and out cables are 3200mm long so can reach easily to the battery box and to each seat. When seats are fitted in the factory fuse position 33 is used and normally not wired unless seats were fitted.

To make the install easier we supply a small box which is wired directly to the battery and provides outputs for the left and right seat which are only live when the engine is running.

The illumination and negative cables are 500mm long so are suitable for splicing into an existing switch.

The cables are colour coded to match the OEM Defender wiring and will plug straight into the orignial Land Rover heated seats as fitted from 2002 and will only require a suitable earth connection for the black wire.

This listing is  TWO harnesses - Switches are NOT supplied

If you want to buy just the black switch connector go here

If you want to buy just the green switch connector go here

If you have a Td4 Tdci Defender made between 2007 and 2016 go here

The Td5 switches are different to that of the later Puma Tdci Defender made from 2007 the Td5 switch is on the left below.

If you buy the Td4 kit which is much cheaper the logo will be on its side but will work just as well.

For further landrover solutions please visit our Ebay store by clicking here