Description

Package Included:
1 x Fiber Cleaver FC-6S
1 x Fiber Optic Stripper CFS-2
1 x Fiber Optic Stripping Tool Plier
1 x Fixed-length Fiber Optic Wire Stripping
1 x Fiber Coating Stripper Cutting Guiderway
1 x Phillips Screwdriver
1 x Large Hex Wrench
1 x Medium Hex Wrench
1 x Small Hex Wrench
1 Pack of Cotton Swabs
1 Pack of Clean Paper
1 x Small Pouch
1 x User Manual

Specifications:
Fiber Cleaver FC-6S
Fiber diameter: 125um
Coating diameter: 250um - 900um
Typical splitter angle: 0.5 degrees
Adjust the peeling length is: 5~20mm
Length of the slit: 9-16mm, 10-16mm
Blade Lifetime: 36,000 columns (3,000 per blade position)

CFS-2 Fiber Stripper
250 um coated layer of 125 um fiber with A.
Opening the top of the B. 1.98mm can be used for stripping fiber outer sheath
The open hole of the type V and 140 um on the edge of the
Clamp can be used to strip the 250 um layer of 125 um fiber
Jaw factory has been adjusted, shall not be adjusted
Will not damage the fiber
A ll the cutting cross section has precise mechanical tolerances to ensure a clean and smooth operation
According to the handle ergonomic design, comfort grip
Does not use the blade, locked in a closed state

Wire Stripper
The use of temperature is -20 ° C ~ 50 °C
Factory pre-set, no need to adjust this stripper again to prevent fiber scratch; cutting blade precision positioning, quenching and tempering treatment, anti-rust primer.
If not use, set the blade lock in the closed state.
For stripping 250 micron buffer coating to expose 125 micron cladded fiber
Second hole for stripping 2-3mm fiber jackets
140 μm diameter hole and V-opening in blade allows removal of 250 micron buffer coating from 125 micron fiber
Pre-set at the factory - no adjustments needed
Will not scratch or nick glass fiber
All stripping surfaces are manufactured to precise tolerances to assure clean, smooth strips
Comfort-grip, ergonomic handles

FTTH Fiber Optic Stripping Tool Kits designed for the installation, operation and maintenance of optical fiber network